Search:

Type: Posts; User: Flatwater

Search: Search took 0.02 seconds.

  1. Replies
    2
    Views
    1,814

    Replying to Topic 'Heater problems in the summer?'

    What year ? How Many hours ? Salt water ?
    A few things come to mind - not fully winterized or damaged from gear or stereo installer or loose calmps. The most common time this occurs is first...
  2. Replies
    1
    Views
    2,359

    Replying to Topic 'Light Bar wiring help'

    You will need to use relays to switch all the power , the ACC switch on the dash will turn on the relays. Don't forget to use the correct size fuse. I would run more wire to allow you some...
  3. Replies
    13
    Views
    5,571

    Replying to Topic 'Water Strainer'

    All the strainers that I have seen have the 90's on them. You generally would want the unit to be sitting up and down or the bowl on the bottom. Hope that helps.
  4. Replies
    13
    Views
    5,571

    Replying to Topic 'Water Strainer'

    Lpfeil

    On the Outback, make sure you install before the tranny cooler. Sometimes you need to wire strap the strainer to the exhaust hose to keep it from banging around. This job is easy compared...
  5. Replies
    14
    Views
    6,296

    Replying to Topic 'Wake Problems'

    Regarding the wake, what speed are you going? With a boat with that much load I think you will need to go a little faster . Also I find that sometimes the ballast bags need to be burped of air. For...
  6. Replies
    1
    Views
    2,182

    Replying to Topic ''01 Mobius running bad'

    I would check your temperature gauge to make sure it is reading 170 - 180 because a stuck open thermostat will run the engine too cool which then tells the computer to run richer. Hope this helps
  7. Thread: 05 Website ?

    by Flatwater
    Replies
    3
    Views
    3,168

    05 Website ?

    Does anyone know when the new site will be up ?
  8. Replies
    6
    Views
    3,494

    Replying to Topic 'Water in ski locker'

    Update on bilge drain

    Here is a link to the shop that carries the item I mentioned above

    http://www.californiamarine.com/images/catalogue/glenwood/page64.pdf
  9. Replies
    6
    Views
    3,494

    Replying to Topic 'Water in ski locker'

    Hey The BleuRue

    On my old jetboat I had a flapper valve similar to the exhaust flappers that I got from the marine store. It was basically a plate that was screwed onto the transom which allowed...
  10. Replies
    1
    Views
    2,007

    Replying to Topic 'Factory Ballast'

    LS Scott

    The factory rear tank should be 350 lbs with the stock front being 450 lbs.
    Last year in a 03 Mobius LS with stock ballast plus two 300 lbs I pulled an advanced rider and his comments...
  11. Replies
    6
    Views
    3,650

    Replying to Topic 'Just bought new Moomba'

    Steve G

    There should be a outlet on each side near transom which overflow pours out of when full. Enjoy the boat.
  12. Replies
    10
    Views
    5,919

    pump priming

    On my 03 Mobius with front and rear ballast sometimes I have to burp the system by turning on the pump while moving forward . I don't have to do this everytime though , I haven't figured out what...
  13. Replies
    4
    Views
    3,941

    bimini top

    Is there a 32 % discount for a fellow canadain ( pay in cdn $ ) ? Will it be shipped from Atlanta or Ontario ?
  14. Thread: wake plate

    by Flatwater
    Replies
    4
    Views
    3,310

    No question , get it !

    I have 03 Mobius DD , I use always for skiing all the way down with a small adjustment up for skiing at 34 mph. Also when running back to the launch, the plate is about midway to stop the bow from...
  15. Replies
    6
    Views
    3,581

    03 Mobius does the same. I see it as two fold...

    03 Mobius does the same. I see it as two fold positve, first it allows for a better top speed ( not that this is why we buy these boats ) and at the wakeboard speeds with ballast it natually will...
  16. Replies
    4
    Views
    3,987

    Flake colours

    I haven't got the 2004 catalogs yet but what I believe what you are referring to is the gel coat option for " iridescent " which was available on all models.
  17. Replies
    7
    Views
    4,925

    Folding Towers

    Thanks Brian
    I understand what you are saying but I am concerned that there is a lot of stresses on these two points which are so close together . Unfortunately my boat spends too much time in my...
  18. Replies
    7
    Views
    4,925

    tower folding on Mobius

    I was wondering where the contact point is for the tower when folded forward . The boat is a Mobius 2003
Results 1 to 18 of 18