Search:

These look fantastic!


Sent from my iPhone using Tapatalk

I would worry about debris falling in the tank when drilling and clogging the fuel pump sock. Can’t get that out unless you empty the clean the tank.

However it may never become an issue if it...

The 550/575 has a more complex cooler mounted in front of the engine that blocks access to the housing. Access is extremely tight.

I worry that it would not be possible to do on the water in an...

I have and it is a major chore. For a couple hours I thought it was impossible too.


Sent from my iPhone using Tapatalk

What an awesome surprise to meet SandM at the ramp and getting a chance to enjoy a beautiful afternoon at Lake Mead on the water. Looking forward to doing it again!


Sent from my iPhone using...

I get oil change reminders in my 2020 SE much more frequently than 50 hours. I wonder if it is simply programmed to remind by hours or other factors like engine load.


Sent from my iPhone...

I have since traded the boat but with the screws and 5200 there was never any signs of movement. I believe the 5200 was giving as much if not more holding power than the screws.


Sent from my...

They have been up and running in Cali for some time now. That’s where I got my SE. They even expanded the SoCal facility over the past few months. Hope to see them expand to other locations!

...

I heard a rumor that you may get a dealer within a couple hours at some point in the future. This would be great because I boat Mead a lot. But you know how rumors are.

I do agree that Vegas...

Interesting knob on the shifter/throttle handle.....


Sent from my iPhone using Tapatalk

Is it thick like ATF or thin like engine coolant? Those are the only two reddish fluids on the boat that I know of.


Sent from my iPhone using Tapatalk

If you can’t get this taken care of locally call Elbert’s in Oregon.


Sent from my iPhone using Tapatalk

Ran it for a few months like that before trading the Max for an SE. No issues after being shortened.


Sent from my iPhone using Tapatalk

The Moomba pipes have the horizontal plate but my understanding is that it was to control spray to not cause cosmetic issues what the wake.


Sent from my iPhone using Tapatalk

I cut the down pipe about an inch lower than the wakeplate in the fully extended position on my old 2018 Max. I also used a clamp and hammer to reshape the pipe to closely match the stock shape at...

I experienced the same issue with bolt failures (upgrades bolts) and cracked flanges until I broke out a saw and shortened the down pipe. No issues after that.


Sent from my iPhone using Tapatalk

It’s best to warm the engine oil and then use a suction extractor.


Sent from my iPhone using Tapatalk

My neighbor has it on loan as a spare for a Powell trip. How we I was looking at it and it probably needs some minor edge repair. Just want to be transparent about what it is.


Sent from my...

113 in Baker, CA at 10pm last night on the drive home. It’s was warm this weekend. Was planning to stay for today but the wind forecast looked bad and the RV air conditioners just could not keep...

Was out on Mead this past weekend. Definitively no need to block a cool breeze with a windscreen. Driving in 119 temps give the feeling of someone holding a hair dryer on your face.


Sent from...

I upgraded from a 2018 Max with over 6000lbs of ballast to an 2020 SE. The wave is better and easier to setup. The Supra transition is smooth, the wave seems to hook more giving more room to play...

Bolt it!


Sent from my iPhone using Tapatalk

Interesting, I can see the pipe now that I look closer. The sensor is just clipped around the hose on my SE.


Sent from my iPhone using Tapatalk

I am not an expert but that sensor just clips around the hose. You can move it as close to the vent as you would like if you have enough wire and a place for it.


Sent from my iPhone using...

Rolled over the CAT scale this past weekend and was surprised by the total weight. This includes 800 lbs of lead (best guess as I can’t remember how many bags I loaded) and a 7/8 full gas tank. I...