Search:

Type: Posts; User: flydoc

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. My packing nut was a little loose and allowing a...

    My packing nut was a little loose and allowing a stream of water in and I am sure that is why my compartment filled up over 2 days. I tightened it and got it to be a slow drip (1 drip/second), so I...
  2. Water in the engine compartment while in the slip! Hopefully its not bad

    Well I let my kids talk me into storing the boat (05 XLV) this summer at the lake. Was fine the first 2 times but my boys left the ballast drain switch on 2 days ago and ran the batteries down. today...
  3. Replies
    23
    Views
    4,035

    Happened to my mobius, it was the oil pressure...

    Happened to my mobius, it was the oil pressure switch. I wired around it and never got around to fixing it. If their is no oil pressure the fuel pump doesnít run so you canít run your engine dry of...
  4. Replies
    2
    Views
    1,651

    I replaced it and it works perfectly. Not sure...

    I replaced it and it works perfectly. Not sure hitch cable I went with but Iíll check.


    Sent from my iPhone using Tapatalk
  5. Thread: Acme 537

    by flydoc
    Replies
    3
    Views
    1,132

    $200 includes shipping lower 48. Sent from...

    $200 includes shipping lower 48.


    Sent from my iPhone using Tapatalk
  6. Thread: Acme 537

    by flydoc
    Replies
    3
    Views
    1,132

    $250 includes shipping in continental us and $50...

    $250 includes shipping in continental us and $50 coupon for nettles repair( if they allow transfer)


    Sent from my iPhone using Tapatalk
  7. Thread: Acme 537

    by flydoc
    Replies
    3
    Views
    1,132

    Acme 537

    I have a spare Acme 537 for sale. I upgraded and have another 537 for a spare. This one has a few minor dings and I was planning on sending to nettles or acme for...
  8. Thread: Obv heat

    by flydoc
    Replies
    1
    Views
    344

    My engine compartment (as well as the v drive...

    My engine compartment (as well as the v drive compartments stay hot for 4 or 5 hours after I'm done boating. Always have from day one. My temp gauge has never shown overheating though. I think it's...
  9. Replies
    5
    Views
    1,066

    That looks awesome. I've made 8 or 9 suck gates...

    That looks awesome. I've made 8 or 9 suck gates and none look as finished or professional as yours. I like the new ideas. Is that a plexiglass top over the suction holder? I've found that 80-90...
  10. I don't ski behind the boat and we split the time...

    I don't ski behind the boat and we split the time between wakeboarding and surfing. It is a little sluggish getting out of the hole so I'd like to add quicker holeshots even at the expense of some...
  11. Any XLV owners running the Acme 1235? Any Clearance issues

    I'm wanting to upgrade my 04 XLV from the Acme 537 prop. I have surf tabs being installed and have the gravity 3 ballast upgrade to 900's plus some extra under observer seat so I want to get a better...
  12. Replies
    37
    Views
    7,660

    Santa brought me a blender for Christmas.

    Santa brought me a blender for Christmas. It looks a lot like a doomswell Neo, but cost a couple hundred buck more. I'd love to find a demo day somewhere and try 5 or 6 boards back to back.
  13. Replies
    37
    Views
    7,660

    You might try to demo a triple x board (skim or...

    You might try to demo a triple x board (skim or surf style) they are a little fragile as they are true surf boards but great behind a boat, or the newer Ronix Blender. Lots different than any of the...
  14. Replies
    2
    Views
    1,533

    I made my own suck gate last summer using HDPE...

    I made my own suck gate last summer using HDPE board and designs like seen on the forum's here and Mastercaraft and malibu sites. The dealer has to mike minimal modifications to the hull to...
  15. Replies
    2
    Views
    1,533

    Putting 2016 Tige' surf tabs on my 04 XLV

    I'm having a Tige/Moomba dealer install the new surf tabs (to be like the new Tige' tabs). Hopefully the need to list my boat as much will be gone and my wave will be more like a new boat. We will...
  16. Did the upgrade help?

    My 05 XLV has the moomba cruise, and it works well except when the boat is heavily weighted while wakeboarding. It speeds up and slows down (kind of over shoots then undershoots the right speed by a...
  17. Replies
    18
    Views
    4,052

    I've used an engine block heater with magnets to...

    I've used an engine block heater with magnets to attach to the bottom of the oil pan. Plug it in for an hour and the oil can be sucked out of the dipstick or drained through the oil drain line very...
  18. Thread: XLV surf tabs

    by flydoc
    Replies
    23
    Views
    7,248

    I am considering having a dealer install tabs...

    I am considering having a dealer install tabs similar to the ones on the new Tige' boats. $3500 installed and the are bigger than the autoflow 1's. Not sure if they are as big as the autoflow 2...
  19. Thread: XLV surf tabs

    by flydoc
    Replies
    23
    Views
    7,248

    XLV surf tabs

    Rather than purchase a new boat I'm thinking of adding surf Tabs to my 04 XLV. It surfs good with a suck gate, but I want a great wake that I can surf further back to get more speed to do 360's and...
  20. Replies
    2
    Views
    1,651

    anyone try the new tfxtreme steering cable?

    I need to replace the steering cable on my 04 XLV. I can't read the cable numbers perfectly but I believe I have a SSC13420 cable ( I can't see the last digit but it has to be a 0 not 1, and my boat...
  21. Thread: steering issue

    by flydoc
    Replies
    6
    Views
    1,815

    can you lift the floor off an XLV to replace cable?

    I have the same problem on my 05 XLV. I am going to take the cable off to see if the wheel moves any easier. Does anyone know on the XLV if you can lift the floor off and where are the screws. I...
  22. Replies
    13
    Views
    8,408

    Overheating XLV, is engine ruined?

    I sold my 98 Mobius yestarday and today almost bought an 04 XLV (I also almost bought a Mastercraft x-10 but the wake stunk and I ran across an 04 XLV - So much better!!!). Anyways the owner was...
  23. Replies
    0
    Views
    1,364

    wanted to buy 2000-2004 mobius V or XLV

    I am interested in purchasing a mobius V (2000-2003) or XLV or LSV. Preferably in the western US as I live in Idaho. I have a 98 Mobius direct drive with beautiful blue metal fleck gel coating that...
  24. Replies
    5
    Views
    4,807

    prop

    I just replaced my'98 mobius prop with an acme. For wakeboarding it is faster out of the hole and may have 1 or 2 less MPH top end. I bought it at propellors online and they have a table that...
  25. Thread: owners manual

    by flydoc
    Replies
    1
    Views
    2,655

    owners manual

    Does anyone know how I can buy a manual for my 98 mobius? Thanks:)
Results 1 to 25 of 29
Page 1 of 2 1 2