Search:

Where are you located?

boat is sold.
thank you.

I will miss the "Blessed Acceleration" when I am trying to get up on one ski.

http://www.entertonement.com/clips/bbnsblhvkm--Our-lady-of-plus-acceleration-don%27t-fail-me-now

It has a lot of...

Thanks, We have really enjoyed this boat. We are moving to a V-Drive.

2000 Moomba Boomerang 19ft ski boat for sale and matching Boatmate trailer.
Low Hours: 205 hrs. 350 Indmar with 310hp. Mostly White with some Red accents. Accessories: CD/Stereo with 4 speakers and...

I am not sure what the part number/supplier is for this tower.
I would look here and see if you can match diameter and thread type.

http://www.mcmaster.com/#thumb-screws/=3na86e

I concur that it is a great addition. $125 seems way too expensive. I bought mine at skidim.com for ~$50
http://www.skidim.com/products.asp?dept=1006

Welcome to Moomba.com I have a 2000 Boomerang with the 310hp Indmar 350.

This is a link to skidim.com and the transmission that would replace the one in my Boomerang. Yours might be...

I had a similar problem back in May. The connection between the fuel pump and the low oil pressure sensor was faulty. Once I re-wired the connection at the sensor it ran fine.

http://www.moomba.com/archive/#
Per the link above the boat itself weighs 2750 by itself. (dry) What about the trailer plus the gas and gear you typically have on board? I would advise against it. ...

What did the impellor look like when you removed the cover?

I am guessing one is your ballast system. (guessing because I don't have one)
I only have one water intake through the hull. Can you open the motor hatch and trace the water line from the raw...

I have a Boomerang which is probably the most sensative of the group. When I am driving alone the boat lists slightly on the driver's side at cruising speed.

I am glad you checked. I wasn't trying to insult your intellegence. I am assuming you offset the spacing/gaps by 90 degrees. interesting problem. I hope someone has some input for the group....

May just want to do a sanity check with the manual and see if you need the 1/4 inch packing. I don't know the spec on Vdrives.

Keep us posted. Did you check your cap and rotor? There could be some real corrosion in there.

What was your RPM's at that time?

How long have you had this boat? Has it had this problem since you have owned it?

I agree with mmandley. The motor running shouldn't cause the bilge to run.

Water coming in from the stern? Have you checked your shaft packing?

Have you observed the engine while running to make sure you don't have any loose hose clamps?

Did the previous owner have any ballast bags installed that could be inavertently filling?

ran great. 50mph and ran out of prop.
2000 Boomerang 180hrs.

zabooda was right. I was poking around SkiDim last night and found the part to which I believe you are referring.

http://www.skidim.com/prodinfo.asp?number=769B

The windshield looks great btw.

My tubes run from the louvers, along the vertical divider and into the floor of the storage compartment. I honestly couldn't tell you where they go from there.

Glad to hear your windshield project turned out so well. It sounds like you got quite a deal. Could you post some pictures?
Also regarding your question on the louvers. I am not sure what you are...