Search:

Bags finally made it!

A little more than 3 months later, my bags are supposedly going to ship tomorrow.

Still waiting on mine...

I'm still waiting on bags ordered two months ago... for a bag with a fitting joint that failed just outside of warranty (which they refused to cover).

Customer service keeps changing the ship...

Yes, the swim platform submerges and I haven't noticed any peeling. I only had to re-adhere maybe 1 square foot total around the entire boat but it has held perfectly everywhere thus far.

My dealer tech recommended gel super glue to hold down peeling foam decking. I used "Loctite Super Glue Ultragel Control" on some peeling corners on the swim platform and dash area and it has held...

I used 3M 5200 to seal up a small leak in the bond between the bag and the apron(?) material around the quick connect fitting. I slathered as much as I could inside and outside the leak/joint and...

I have a pair if interested.

Saw this at a boat show, seemed like a good compromise between ease of use, cost and protection.
https://boathouseshades.com/

We have a Zup and it is great for getting kids on the water. It is really stable and not as intimidating as most other boards, so it helps them build confidence much more quickly. If you have kids...

In looking at my setup, I also think it is just a spacer you don't need. Mine is installed with swivel, but I don't notice where there would be interference without it. Roswell's instructions even...

I used uship as well. Some of the initial quotes were ridiculous, but after a few days I had several reasonable quotes from highly rated shippers. I picked one and was very pleased with the process...

I really like Slingshot foils. Super interchangeable, tons of options, and reasonable price and quality.

A foil specific board helps when you are learning, but after that the board isn't of...

Anyone happen to know exactly how the ballast hoses are routed inside the hull (2017 Helix)?

I have a hairline split in the inlet hose just in front of the (starboard rear) ballast bag inlet. ...

I've used a Fenix watch with Fusion head unit, worked great. Would always lose connection when going in the water though, understandably.

I used to have a water trampoline and didn't like it. It is fine to hang out on and float, but it hardly has any bounce, nothing like a regular trampoline.

Mine is wired to the farthest left toggle switch. Up turns on the radio, which from the factory would have been the heater on high (plenty of amperage).

I don't think so, if I remember correctly each side of the split section has 4 bolt holes in a square drill pattern in each. You can confirm by pulling them apart, just a few allen head bolts...

I've got the Helix, and the wake is excellent for the size, I'm sure you would love it. That said, the bigger options will give you a bigger wave.

I think they're 650 pounds each side plus 400/400 up front for 2100 total. Wakemakers has 1140 (I think they recently bumped up to 1190) each side, work great, make the difference in the wave.

Pretty sure the quick release/swivel/etc. for the Roswell Moomba design are all pretty interchangeable. I removed my quick releases, so now my connection goes from the tower straight to the swivel...

I installed the "Firewatermarine Super Delux 10 WATT Garboard Brass Boat Plug Light 1000-1200 LUMENS", $25 at amazon. The light doesn't blow you away, but it's great for the price. I did have to...

Mine is usually around 165, hottest I've ever noticed was about 169 (used in central Florida, so water and air temps max out around 90 and 95 respectively).

The wires are in the engine bay, against the stern wall on the starboard side (not by all of the junction boxes on the port side).
Take off the black plastic decorative "Moomba" thing for more...

My fitting with zip tie eventually popped again. It stayed for a long time, but popped immediately after I was jostling the bag around when working in the engine bay.
I think the hose/bag need to...