Search:

Type: Posts; User: DOCDRS

Page 1 of 20 1 2 3 4

Search: Search took 0.10 seconds.

  1. Replies
    8
    Views
    198

    If you rotated the shaft and all tolerances did...

    If you rotated the shaft and all tolerances did not change , then your shaft is not bent ( at least from the strut to the coupler. If you are still up and to the right and not touching and see no...
  2. Replies
    23
    Views
    645

    I definitely agree with you, but if you are going...

    I definitely agree with you, but if you are going to spend the time to do it you might as well do it right and know the reasons why. But then again sometimes I get lazy and just change the oil and...
  3. Replies
    23
    Views
    645

    Oh yay , now that is a better analogy.

    Oh yay , now that is a better analogy.
  4. Replies
    8
    Views
    198

    So if you move the front of the motor in the 3...

    So if you move the front of the motor in the 3 oclock direction will that help more center the shaft? Im assuming you have a vdrive
  5. Replies
    8
    Views
    198

    What does fairly well mean? You have to take the...

    What does fairly well mean? You have to take the four bolts out as well as loosen the hull boot clamps and the boot, and pull it off the hull side to take any stress out. Then see where the strut...
  6. Replies
    23
    Views
    645

    Would you rather go to bed dirty and fester in...

    Would you rather go to bed dirty and fester in your acidic sweaty body all winter long or go to bed in nice fresh clean new jammies sheets and skin?........
  7. Replies
    8
    Views
    198

    If its not rubbing dont worry. Do check your...

    If its not rubbing dont worry. Do check your shaft coupler to vdrive coupler alignment. ie. your engine alignment. Wet your cutlass bearing to free up the propshaft. Then check the lateral play,...
  8. Replies
    23
    Views
    645

    Just checked the primo muskoka price. Full...

    Just checked the primo muskoka price. Full winterization with drain and antifreeze flush of engine,ballast,heater, plus oil n filter change, plus a few extra nice things is 699 cad . A very...
  9. Replies
    19
    Views
    616

    Please note that these closed systems use a...

    Please note that these closed systems use a propylene/water mixture in the block and it has to be tested to verify the freeze protection and adjusted acording to your weather conditions during...
  10. Replies
    19
    Views
    616

    My turn...... Hmmmm, That photo seemed to post...

    My turn...... Hmmmm, That photo seemed to post fairly easy, but maybe no one else can see it.

    I PM'd the OP , as I like to keep these things private, but the OP decided to go public. Yes I did...
  11. Replies
    19
    Views
    616

    26445 Photo post attempt

    26445

    Photo post attempt
  12. Replies
    16
    Views
    476

    There has to be some play to allow for the...

    There has to be some play to allow for the lateral movement due to the arc the rudder arm makes. As long as there is no bow to stern play
  13. Replies
    22
    Views
    743

    This is for all the dumb dumbs out there who...

    This is for all the dumb dumbs out there who think they can just suck up 5 gal of antifreeze in their raw water cooled indmars and get all excited when they see pink coming out the exhaust that they...
  14. Replies
    4
    Views
    149

    On my 99 outback I wire brushed it then coated it...

    On my 99 outback I wire brushed it then coated it with roofing tar
  15. Replies
    11
    Views
    261

    Place a decal on your boat that lines up with the...

    Place a decal on your boat that lines up with the forward vertical guide post where you want the boat on the lift. You can place a second one toward the stern that marks the most forward location...
  16. Make sure you run your engine after you change...

    Make sure you run your engine after you change the oil so that everything is coated with fresh oil not old dirty acidic oil. Be very careful using the dipstick tube as the plastic vacuum tube can get...
  17. I would take a wire and poke your drain holes as...

    I would take a wire and poke your drain holes as sometimes rust can block and prevent all the water from draining. Not sure why you sucked up the antifreeze before you drained it as most of it would...
  18. Replies
    22
    Views
    743

    IF YOU HAVE DRAINED THE BLOCK. YES......NO, IF...

    IF YOU HAVE DRAINED THE BLOCK. YES......NO, IF you have water in your block.
  19. Replies
    22
    Views
    743

    Sorry, but was not sure why you would run your...

    Sorry, but was not sure why you would run your boat to temperature before hand......glad you drain before though...... I always hate hearing about cracked manifolds, blocks or heaters in the spring.
  20. Replies
    22
    Views
    743

    Dont do this, at temp the thermostat just begins...

    Dont do this, at temp the thermostat just begins to open. Most of the antifreeze will bypass the engine and go to the exhaust and out the muffler.
    If you drain your block then hook up the intake...
  21. Replies
    3
    Views
    163

    So I take it you hit something to require a new...

    So I take it you hit something to require a new shaft , cutlass bearing and straightening of the strut........did you get a new prop as well? You know that the prop shaft should not be in perfect...
  22. Replies
    7
    Views
    340

    Assuming you have had your Vdrive oil and tranny...

    Assuming you have had your Vdrive oil and tranny oil changed already
  23. Replies
    7
    Views
    340

    Why would they water test it for a...

    Why would they water test it for a winterization?????? before hand so they could go skiing and warm up the oil???
  24. Replies
    7
    Views
    340

    Seriously, are you retarded? Just kidding, but...

    Seriously, are you retarded? Just kidding, but what exactly are they doing for 600. If you have ever done it yourself you will wonder, it takes all of 2 hours tops. I hope that includes wrapping it...
  25. Replies
    18
    Views
    998

    C. Can't hurt so why not. Depends where and how...

    C. Can't hurt so why not. Depends where and how damp your storage area is imo I store mine on my lift inside my boat port all winter long with no dry eze stufff but a few bounce sheets to keep...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4