Search:

Type: Posts; User: Holdmybeer

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Not sure about the 7" screen interface. I...

    Not sure about the 7" screen interface.

    I know when I upgraded my stereo I had to add a power pigtail to the nmea2000 network. The RA70 provides voltage to the network but the other stereos do...
  2. Not sure about the new covers. My 2015 cover has...

    Not sure about the new covers. My 2015 cover has access for the cleats. Also have a zippered access forbthe full door.

    Wonder why Skiers would have changed that?
  3. Replies
    11
    Views
    328

    Very familiar with this concept. However, are you...

    Very familiar with this concept. However, are you familiar with letting a sleeping dog lie?

    This man went through the time to build something for his own personal gain and enjoy it. Instead of...
  4. Replies
    11
    Views
    328

    Great work! How does it sound? For what you...

    Great work! How does it sound?

    For what you have in it, if the box last 2 years it will be good enough. More than likely will last longer. Just make sure to leave the seat off when being stored...
  5. Replies
    27
    Views
    4,717

    That tool was worth the $40 several years ago. ...

    That tool was worth the $40 several years ago. It has also netted me lots of free beer for helping.
  6. Replies
    7
    Views
    220

    Under the port side locker is a 12v bus lug and...

    Under the port side locker is a 12v bus lug and ground lug that the amps use. They come straight from the battery switch and would be where I would clamp to for you pump.
  7. Replies
    6
    Views
    124

    Actually I am wrong here. The replacement pump...

    Actually I am wrong here. The replacement pump is a Jabsco Puppy 18670 series - 8-9 GPM. They are $385 and discontinued.

    Wakemakers is selling you a 18220 series which is 9gpm at $250 and the...
  8. Replies
    2
    Views
    80

    Low oil level. If you had your key on while...

    Low oil level. If you had your key on while changing oil it triggers it. Like myself most people have the radio on while doing maintenance.

    If this is not the case, please check your oil.
  9. Replies
    6
    Views
    124

    The windings are shot. Not worth rebuilding. ...

    The windings are shot. Not worth rebuilding. New one is $200, and I never have seen a rebuild kit for the motor.
  10. Replies
    39
    Views
    16,182

    It will fit jist fine. You only have a single...

    It will fit jist fine. You only have a single strut verses the double strut of the newer boats. You can either cut a groove in the front and make it fit around strut mount OR change to a dual strut...
  11. Replies
    111
    Views
    89,036

    Sticky: It would be awesome if my spin on was top mounted...

    It would be awesome if my spin on was top mounted and not hanging. Makes a mess everytime hanging down.
  12. Replies
    10
    Views
    262

    If you have the G3 system...3 pumps. All the...

    If you have the G3 system...3 pumps. All the ballast pumps are behind false walls on the back rear lockers. If you have the G6 system....6 pumps. The 2 ballast pumps for the mid/front are under the...
  13. Replies
    37
    Views
    2,266

    Just some friendly advise....the screw on clevis...

    Just some friendly advise....the screw on clevis comes loose over time. Quick way to throw a box anchor out and get nothing but the leader pole back. You can run stainless steel wire through the...
  14. Replies
    12
    Views
    459

    Is this the amp for the 6 cabin/bow speakers? Is...

    Is this the amp for the 6 cabin/bow speakers? Is this also your subwoofer amp?
  15. Replies
    51
    Views
    74,744

    If you crawl under the dash the factory harness...

    If you crawl under the dash the factory harness is just a couple of white connectors.

    The Fusion radio harness is wired to 1 of those. Follow the red and yellow wires directly from the back of...
  16. Replies
    3
    Views
    382

    How does that do with GSA and "surf gate"...

    How does that do with GSA and "surf gate" combined?

    Any videos?
  17. Replies
    51
    Views
    74,744

    This might be true for newer boats but my 2015...

    This might be true for newer boats but my 2015 was not. The yellow and red were connected via factory harness and landed on switched power from the key.

    I have since separated them so yellow is...
  18. Replies
    8
    Views
    498

    The thread pitch should be the same. I forgot...

    The thread pitch should be the same. I forgot that the flange one is low profile version. The picture is a screen shot from McMaster Carr. I would go Stainless


    30846
  19. Replies
    8
    Views
    498

    Yes that will work. The shaft 1-1/8". I...

    Yes that will work.
    The shaft 1-1/8". I installed a Glide Bearing in mine. Tim @Glide is a good guy and price was right.

    I thought the prop nut and and v-drive coupler nut were the same size. ...
  20. Replies
    8
    Views
    498

    So....that should never happen. Did someone...

    So....that should never happen.

    Did someone service your boat recently? The shaft is tapered which makes it easy to get in but not out. Also my 2015 that nut is torqued 65-70lb-ft. I also...
  21. Replies
    12
    Views
    459

    I have seen this wiring several ways. ...

    I have seen this wiring several ways.

    4-channel amp - bow is channel 3 and 4 and cabins are bridged. Port side 2 speakers channel 1 and starboard side 2 speakers channel 2. The bridged channels...
  22. Replies
    12
    Views
    459

    6.5 will fit. There is nothing in the bow to...

    6.5 will fit. There is nothing in the bow to really reflect the sound. Almost needs free air 6.5 speakers.

    Your lack of forward volume is probably based on wiring/amp configuration. Most likely...
  23. Replies
    10
    Views
    839

    Best part of that video.....Supercharger whine!

    Best part of that video.....Supercharger whine!
  24. Replies
    3
    Views
    377

    Over heating usually warps the metal and causes...

    Over heating usually warps the metal and causes dissimmetals to seize. Aluminum pistons will swell and burn out the rings before melt down. The iron block swells at a different rate and the pistons...
  25. From their website replacement parts it list a...

    From their website replacement parts it list a Fuel Formula 1 255/55r18. I had trouble finding them. This was the only listing. I would buy something else that is easily replacable. Boatmate...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4