Search:
Type: Posts; User: flydoc
Search: Search took 0.01 seconds.
-
06-16-2019, 11:27 PM
- Replies
- 3
- Views
- 3,741
My packing nut was a little loose and allowing a...
My packing nut was a little loose and allowing a stream of water in and I am sure that is why my compartment filled up over 2 days. I tightened it and got it to be a slow drip (1 drip/second), so I...
-
06-14-2019, 11:52 PM
- Replies
- 3
- Views
- 3,741
Water in the engine compartment while in the slip! Hopefully its not bad
Well I let my kids talk me into storing the boat (05 XLV) this summer at the lake. Was fine the first 2 times but my boys left the ballast drain switch on 2 days ago and ran the batteries down. today...
-
05-01-2019, 11:50 PM
Thread: Fuel Pump has no Power
by flydoc- Replies
- 23
- Views
- 19,325
Happened to my mobius, it was the oil pressure...
Happened to my mobius, it was the oil pressure switch. I wired around it and never got around to fixing it. If their is no oil pressure the fuel pump doesn’t run so you can’t run your engine dry of...
-
07-21-2018, 12:40 AM
- Replies
- 2
- Views
- 2,217
I replaced it and it works perfectly. Not sure...
I replaced it and it works perfectly. Not sure hitch cable I went with but I’ll check.
Sent from my iPhone using Tapatalk -
$200 includes shipping lower 48. Sent from...
$200 includes shipping lower 48.
Sent from my iPhone using Tapatalk -
$250 includes shipping in continental us and $50...
$250 includes shipping in continental us and $50 coupon for nettles repair( if they allow transfer)
Sent from my iPhone using Tapatalk -
Acme 537
I have a spare Acme 537 for sale. I upgraded and have another 537 for a spare. This one has a few minor dings and I was planning on sending to nettles or acme for...
-
My engine compartment (as well as the v drive...
My engine compartment (as well as the v drive compartments stay hot for 4 or 5 hours after I'm done boating. Always have from day one. My temp gauge has never shown overheating though. I think it's...
-
08-04-2017, 01:09 PM
Thread: One off Suck gate
by flydoc- Replies
- 5
- Views
- 1,522
That looks awesome. I've made 8 or 9 suck gates...
That looks awesome. I've made 8 or 9 suck gates and none look as finished or professional as yours. I like the new ideas. Is that a plexiglass top over the suction holder? I've found that 80-90...
-
04-17-2017, 04:05 PM
- Replies
- 7
- Views
- 2,206
I don't ski behind the boat and we split the time...
I don't ski behind the boat and we split the time between wakeboarding and surfing. It is a little sluggish getting out of the hole so I'd like to add quicker holeshots even at the expense of some...
-
04-16-2017, 07:45 PM
- Replies
- 7
- Views
- 2,206
Any XLV owners running the Acme 1235? Any Clearance issues
I'm wanting to upgrade my 04 XLV from the Acme 537 prop. I have surf tabs being installed and have the gravity 3 ballast upgrade to 900's plus some extra under observer seat so I want to get a better...
-
04-16-2017, 05:55 PM
Thread: New Board Search
by flydoc- Replies
- 37
- Views
- 12,685
Santa brought me a blender for Christmas.
Santa brought me a blender for Christmas. It looks a lot like a doomswell Neo, but cost a couple hundred buck more. I'd love to find a demo day somewhere and try 5 or 6 boards back to back.
-
04-16-2017, 04:56 PM
Thread: New Board Search
by flydoc- Replies
- 37
- Views
- 12,685
You might try to demo a triple x board (skim or...
You might try to demo a triple x board (skim or surf style) they are a little fragile as they are true surf boards but great behind a boat, or the newer Ronix Blender. Lots different than any of the...
-
04-16-2017, 12:39 PM
Thread: Putting 2016 Tige' surf tabs on my 04 XLV
by flydoc- Replies
- 2
- Views
- 3,133
I made my own suck gate last summer using HDPE...
I made my own suck gate last summer using HDPE board and designs like seen on the forum's here and Mastercaraft and malibu sites. The dealer has to mike minimal modifications to the hull to...
-
04-16-2017, 11:58 AM
Thread: Putting 2016 Tige' surf tabs on my 04 XLV
by flydoc- Replies
- 2
- Views
- 3,133
Putting 2016 Tige' surf tabs on my 04 XLV
I'm having a Tige/Moomba dealer install the new surf tabs (to be like the new Tige' tabs). Hopefully the need to list my boat as much will be gone and my wave will be more like a new boat. We will...
-
04-16-2017, 11:52 AM
- Replies
- 8
- Views
- 2,199
Did the upgrade help?
My 05 XLV has the moomba cruise, and it works well except when the boat is heavily weighted while wakeboarding. It speeds up and slows down (kind of over shoots then undershoots the right speed by a...
-
04-16-2017, 11:43 AM
Thread: Running engine while on trailer
by flydoc- Replies
- 18
- Views
- 6,078
I've used an engine block heater with magnets to...
I've used an engine block heater with magnets to attach to the bottom of the oil pan. Plug it in for an hour and the oil can be sucked out of the dipstick or drained through the oil drain line very...
-
03-15-2017, 03:02 PM
Thread: XLV surf tabs
by flydoc- Replies
- 23
- Views
- 15,863
I am considering having a dealer install tabs...
I am considering having a dealer install tabs similar to the ones on the new Tige' boats. $3500 installed and the are bigger than the autoflow 1's. Not sure if they are as big as the autoflow 2...
-
02-19-2017, 03:56 AM
Thread: XLV surf tabs
by flydoc- Replies
- 23
- Views
- 15,863
XLV surf tabs
Rather than purchase a new boat I'm thinking of adding surf Tabs to my 04 XLV. It surfs good with a suck gate, but I want a great wake that I can surf further back to get more speed to do 360's and...
-
05-02-2010, 07:04 PM
- Replies
- 2
- Views
- 2,217
anyone try the new tfxtreme steering cable?
I need to replace the steering cable on my 04 XLV. I can't read the cable numbers perfectly but I believe I have a SSC13420 cable ( I can't see the last digit but it has to be a 0 not 1, and my boat...
-
02-28-2010, 01:44 AM
Thread: steering issue
by flydoc- Replies
- 6
- Views
- 2,209
can you lift the floor off an XLV to replace cable?
I have the same problem on my 05 XLV. I am going to take the cable off to see if the wheel moves any easier. Does anyone know on the XLV if you can lift the floor off and where are the screws. I...
-
06-07-2009, 03:47 AM
Thread: Overheating XLV, is engine ruined?
by flydoc- Replies
- 13
- Views
- 13,020
Overheating XLV, is engine ruined?
I sold my 98 Mobius yestarday and today almost bought an 04 XLV (I also almost bought a Mastercraft x-10 but the wake stunk and I ran across an 04 XLV - So much better!!!). Anyways the owner was...
-
08-21-2007, 07:12 PM
Thread: wanted to buy 2000-2004 mobius V or XLV
by flydoc- Replies
- 0
- Views
- 1,726
wanted to buy 2000-2004 mobius V or XLV
I am interested in purchasing a mobius V (2000-2003) or XLV or LSV. Preferably in the western US as I live in Idaho. I have a 98 Mobius direct drive with beautiful blue metal fleck gel coating that...
-
05-29-2003, 04:49 PM
Thread: Outback Propeller
by flydoc- Replies
- 5
- Views
- 5,741
prop
I just replaced my'98 mobius prop with an acme. For wakeboarding it is faster out of the hole and may have 1 or 2 less MPH top end. I bought it at propellors online and they have a table that...
-
03-24-2003, 12:09 AM
Thread: owners manual
by flydoc- Replies
- 1
- Views
- 3,138
owners manual
Does anyone know how I can buy a manual for my 98 mobius? Thanks:)
Results 1 to 25 of 29