Search:

Type: Posts; User: smallfield

Search: Search took 0.01 seconds.

  1. Replies
    14
    Views
    3,717

    I have the cylinder. I may go ahead and swap the...

    I have the cylinder. I may go ahead and swap the impeller. Only changed it once so far when I asked my dealer to do it. They did not recommend it until I asked, but service less good in my area...
  2. Replies
    14
    Views
    3,717

    A few questions - my first go at this Looking...

    A few questions - my first go at this

    Looking at my 2017 Helix manual it seems there are just 3 blue plugs (side and bottom of heat exchanger and front of V drive) and you undo the two hoses that...
  3. Replies
    8
    Views
    7,340

    Actually most the vibration turns out to be...

    Actually most the vibration turns out to be between the glass and the softer dash material. Some moderate density foam really dampened it well. May lay the vinyl on the front side, but really loud...
  4. Replies
    2
    Views
    895

    Dang. Worried about that. My dealer is 2h away...

    Dang. Worried about that. My dealer is 2h away and would probably take the season to fix - only a few weeks left here. I will warranty it when season is over if no one has more troubleshooting ideas....
  5. Replies
    2
    Views
    895

    Wakeplate problem

    I have a 2017 Helix and my wakeplate stopped working. Set at 52%. I don’t see a fuse - disconnected after relay and no power going to the plate. Is there a fuse? Can you reset the autowake computer?...
  6. If they tapped speakers (pleural) I’d bet...

    If they tapped speakers (pleural) I’d bet polarity is reversed on one. For a mono amp you really just need to tap one, right? Disconnect or reverse one of the two speaker connections and see what...
  7. Replies
    8
    Views
    7,340

    Ordered today - May need some bracing too as dash...

    Ordered today - May need some bracing too as dash moves a lot. What do you think about putting the 315 foam on top of the base later - know some auto guys doing the same 80mil you recommend then...
  8. Replies
    8
    Views
    7,340

    Done

    And the final product:

    28956

    It is pretty loud, but lots of dash rattles. I’m going to mat it and have closed off some of the holes on the back of the dash with some success. I’ll get to...
  9. Replies
    8
    Views
    7,340

    While there has to be a better way, all I could...

    While there has to be a better way, all I could think of was a Dremmel with a carbide tip attachment. I used this due to limited clearance for a router or jig saw. Took a bit as the Dremmel got hot...
  10. Replies
    8
    Views
    7,340

    First, I used my router to cut a template of the...

    First, I used my router to cut a template of the surround. I then marked on it where the screws go and mounted my surround template

    28953
  11. Replies
    8
    Views
    7,340

    Installing JL M7 IB subwoofer in Helix

    This was pretty scary to do without pictures due to limited clearance so I figured I’d post what I did and see if it helps anyone.
  12. Replies
    532
    Views
    152,131

    Sent last 2 after getting code

    Sent last 2 after getting code
  13. Replies
    532
    Views
    152,131

    Can I get the code? Getting new rear sacks and...

    Can I get the code? Getting new rear sacks and braces
Results 1 to 13 of 13