Search:

Type: Posts; User: SkiBoy

Page 1 of 6 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    4
    Views
    4,928

    I have a 99 LS and every year, sometimes twice a...

    I have a 99 LS and every year, sometimes twice a season, I lube the rudder. I can turn the wheel with one finger all the way right and left.
    If you have lubed the Zerk fitting, it must be the...
  2. Replies
    15
    Views
    88,663

    Thanks for your help on this. I missed a few...

    Thanks for your help on this. I missed a few runs and chased some sounds, but all is good for now. With a 27 year old boat, things go wrong and I hear 'sounds' now and then.

    I will check the...
  3. Replies
    15
    Views
    88,663

    I have three ski runs since I got the new flax...

    I have three ski runs since I got the new flax packing and tightened the V belt. Runs great no sounds coming from the circulator or shaft area.
    I was worried I had the belt too tight, so I backed...
  4. Replies
    15
    Views
    88,663

    I tightened the belt and the noise almost is...

    I tightened the belt and the noise almost is silent. I don't want to overtighten, but I may go a bit more.
  5. Replies
    15
    Views
    88,663

    Checked all brass on shaft. All tight under and...

    Checked all brass on shaft. All tight under and above, no slop. Watched it run in and out of gear, no unusual sound or movement. I have always changed the fluid yearly.

    All this started after I...
  6. Replies
    15
    Views
    88,663

    Skied behind it this morning. The sound is coming...

    Skied behind it this morning. The sound is coming from the circulator. Not as loud as yesterday and the boat runs like new. Smooth acceleration and no noise until rpms get low then the kkkck sound...
  7. Replies
    15
    Views
    88,663

    After I warmed it up, we pulled out to ski and it...

    After I warmed it up, we pulled out to ski and it made the kkkck sound in gear and out of gear.

    It's hard to determine where the sound is coming from, but it only happens at low rpm. Lifted the...
  8. Replies
    15
    Views
    88,663

    A different noise now. Once I repacked the...

    A different noise now. Once I repacked the flax, doing all recommended procedures, we skied twice and no issues.
    Sat on the water for a while and started it up to head to the dock. A tic tic...
  9. Replies
    15
    Views
    88,663

    I dug out the old flax packing. There were two...

    I dug out the old flax packing. There were two pieces one was destroyed and in tatters. The other was in decent shape, but I think I over tightened the nut (by hand) and it caused it to vibrate when...
  10. Replies
    15
    Views
    88,663

    I had a guy in the boat tonight recording sound....

    I had a guy in the boat tonight recording sound. When I shift from neutral it makes a sound. He said it’s coming from the back and thinks it’s the shaft. Sound is not as loud as the last few days. I...
  11. Replies
    15
    Views
    88,663

    Checked the shaft packing, all good. I recall in...

    Checked the shaft packing, all good. I recall in the past overtightening the nut and it zinged on the shaft. I only hand tighten now to a slow drip every several seconds or so. That is not the sound...
  12. Replies
    15
    Views
    88,663

    I check the impeller a few times a year. All the...

    I check the impeller a few times a year. All the 'fingers' are there and it seems to be pumping well. Temp stays around 160. Packing seal I adjusted twice this year. I have a new piece, will put that...
  13. Replies
    15
    Views
    88,663

    Intermittent scraping noise coming from engine

    Sometimes happens in gear, sometimes at idle. Not every time I operate the boat.
    Boat is running fine not over heating.
    It's a short kkkkch and then nothing. I rev the engine and all is good, or...
  14. Replies
    3
    Views
    8,980

    I hear you. My 99 Outback just fits in the...

    I hear you. My 99 Outback just fits in the garage if the stern lines up with the trailer. Unless the water level at the launch is high, it is very difficult to get it over the roller. Mine just fits...
  15. Thread: Engine rattle

    by SkiBoy
    Replies
    9
    Views
    11,363

    Thanks, will back it off a bit.

    Thanks, will back it off a bit.
  16. Thread: Engine rattle

    by SkiBoy
    Replies
    9
    Views
    11,363

    Wondering if I tightened the belt too much when...

    Wondering if I tightened the belt too much when reassembling.
    The alternator is hot to the touch. It is close to the engine and I never checked before. I also smell a very faint electrical scent now...
  17. Thread: Engine rattle

    by SkiBoy
    Replies
    9
    Views
    11,363

    Swapped out the upper circulator. Took about an...

    Swapped out the upper circulator. Took about an hour. Pinging sound went away and boat is running well. The old part seems to be working but was vibrating and somehow touching the aluminum back...
  18. Thread: Engine rattle

    by SkiBoy
    Replies
    9
    Views
    11,363

    Pretty sure it’s the upper water pump. Started...

    Pretty sure it’s the upper water pump.
    Started it this morning and the rattle is coming from that area.
    Changed tha more than ten years ago, not difficult with help, but looks like I’m off the...
  19. Thread: Engine rattle

    by SkiBoy
    Replies
    9
    Views
    11,363

    Oil fresh only 3 ski runs since I put it on the...

    Oil fresh only 3 ski runs since I put it on the water Sunday.
    Holley marine avenger carb, oil level good on stick, no gauge.
    I noticed the noise when idling after the ski. Turned it off. Started...
  20. Thread: Engine rattle

    by SkiBoy
    Replies
    9
    Views
    11,363

    Engine rattle

    Sounds like top end rattle. Off and on, no loss of power.
    99 Outback L S with 1200 hrs.
    Rattled a bit at idle then went away.

    Don’t recall hearing this before.

    Any ideas or experience in...
  21. Thread: Not starting

    by SkiBoy
    Replies
    48
    Views
    406,567

    Finally got the right distributor and installed...

    Finally got the right distributor and installed it today with some help from a mobile marine mechanic. Boat runs great but it sounds a bit different. Maybe because I haven't run it in three weeks....
  22. Thread: Not starting

    by SkiBoy
    Replies
    48
    Views
    406,567

    Ordered a basic replacement distributor. Going...

    Ordered a basic replacement distributor. Going to have a mobile marine mechanic help me install it and trace any other spark/ground/wiring issues.
    Will report back.
  23. Thread: Not starting

    by SkiBoy
    Replies
    48
    Views
    406,567

    No ECM on my Outback. I think I will buy an...

    No ECM on my Outback. I think I will buy an electronic distributor and get some help installing it.

    Marine HEI Electronic Distributor 65K Coil - Compatible with 350 5.7
  24. Thread: Not starting

    by SkiBoy
    Replies
    48
    Views
    406,567

    Went out to ski at 8 this morning, lost spark...

    Went out to ski at 8 this morning, lost spark idling across the lake. Jiggled wires, touched all the connections and sensor spots unplugged the modulator and coil, tried all what I have been doing...
  25. Thread: Not starting

    by SkiBoy
    Replies
    48
    Views
    406,567

    Thanks for the info guys. I installed a new...

    Thanks for the info guys. I installed a new modulator, and she runs like a top. Second day out my fuel pressure dropped and she stumbled and died. Added gas to the carb,it fired and quit. I...
Results 1 to 25 of 134
Page 1 of 6 1 2 3 4