Search:

Type: Posts; User: ranger098

Search: Search took 0.01 seconds.

  1. Replies
    2
    Views
    2,773

    What engine is in that? Can you drive around and...

    What engine is in that? Can you drive around and keep it running if the RPMs are up?
  2. Replies
    2
    Views
    589

    Thanks for the reply, ill lake test it before...

    Thanks for the reply, ill lake test it before pursuing any further because on the trailer it runs and starts perfect. appreciate you sharing the part number though to make it easy
  3. Replies
    2
    Views
    589

    Setting base timing, no marks?

    2002 mobius LSV Carb, went to set / adjust base timing, but the crank pulley only has one mark instead of several (indicating TDC, -10TDC, -20TDC, etc.) the engine should be set to 10 degrees under...
  4. Replies
    15
    Views
    3,269

    Any update here? i have a similar issue that...

    Any update here? i have a similar issue that remains a mystery to me, im about in the same place as you. looking at the carb.
  5. Replies
    11
    Views
    4,501

    you can try disconnecting your PP guage, see if...

    you can try disconnecting your PP guage, see if that makes a diff. Theres an article floating around here somewhere that says you can move the power for the PP from the tach to another location and...
  6. Replies
    14
    Views
    2,572

    So I did some more poking around today and found...

    So I did some more poking around today and found that at idle, the purple wire on the alternator is putting out about 11v. Main orange wire is a good 13.9-14. What’s the right voltage for that purple...
  7. Replies
    14
    Views
    2,572

    It varies with the RPMs, but it’s definitely not...

    It varies with the RPMs, but it’s definitely not 13, I’m usually happy to see 12 volts, but it’s usually under 12. Power has always been low at the dash too
  8. Replies
    14
    Views
    2,572

    I need to revive this thread, the issue remains...

    I need to revive this thread, the issue remains and ive learned a little more now.

    After about 20 minutes of running, the issue will go away and not come back for the day. Another interesting...
  9. Replies
    14
    Views
    2,572

    UPDATE seems to be a bad ignition control...

    UPDATE

    seems to be a bad ignition control module, i took that off the distributor and there was a little corrosion on two prongs. cleaned that and reinstalled for testing and it ran perfect. ...
  10. Replies
    14
    Views
    2,572

    Yes two of the 4 barrels are open which as i...

    Yes two of the 4 barrels are open which as i understand is normal when revving in neutral (not under load). I havent looked when someone else is driving. Ill try some gas into the carb though, good...
  11. Replies
    14
    Views
    2,572

    Neither slow or fast will change the issue, also...

    Neither slow or fast will change the issue, also it's not strictly 3000 RPM, yesterday it started around 2000, and couldnt get to 3000.

    P.S. i got half a mind to buy your boat from you...
  12. Replies
    14
    Views
    2,572

    what part of the electronic ignition? I am...

    what part of the electronic ignition? I am thinking of checking further into the distributor or ignition module...
  13. Replies
    14
    Views
    2,572

    I havent done that yet, could this also make my...

    I havent done that yet, could this also make my tach jump around though? That's the main reason i havent messed with the carb.
  14. Replies
    5
    Views
    1,319

    Disconnect your negative battery terminal, the...

    Disconnect your negative battery terminal, the starter is right there and if you tap it right youll make sparks. Other than that nothing special, just did mine yesterday and there wasnt even much...
  15. Replies
    14
    Views
    2,572

    Indmar Bogging

    Boat did this a little bit last year, and this year seems to be worse. She will start and idle fine, and rev up to about 2500-3000 RPM, but cannot go past that, falls on its face. Its almost like...
  16. Replies
    3
    Views
    1,456

    It depends on where your issue lies. But yes,...

    It depends on where your issue lies. But yes, grease the rudder first. If that doesnt work, then replace the cable.
  17. I have this issue randomly too, happened when i...

    I have this issue randomly too, happened when i replaced my steering cable. I think if you were to shift it around (under the floor) and just reposition it a little, it wouldnt hit anything and it...
Results 1 to 17 of 17