Search:

Type: Posts; User: MLA

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    44
    Views
    5,249

    Marine illumination blue. May have a black...

    Marine illumination blue. May have a black tracer, but the primary color is usually blue.
  2. Replies
    27
    Views
    428

    In the context of this thread, a boat using an...

    In the context of this thread, a boat using an OEM ECM, there is no power benefit to running a higher then recommended octane.

    Now, in the custom world, there is a benefit to using higher octane....
  3. Replies
    27
    Views
    428

    I would clarify that this is when building an...

    I would clarify that this is when building an engine and writing a custom tune (if an ECM controlled engine) but would not be the results in a "street" engine thats designed for typical pump gas and...
  4. Replies
    27
    Views
    428

    Its all E10 unless it states: E85 E15...

    Its all E10 unless it states:

    E85
    E15
    Non-Ethanol.
  5. Replies
    27
    Views
    428

    There is a push to up to E15. Its all driven by...

    There is a push to up to E15. Its all driven by $$$, by those that stand to profit from it.
  6. Replies
    27
    Views
    428

    E = ethanol and the 10 = no more then 10%...

    E = ethanol and the 10 = no more then 10% ethanol. So 89 oct or higher is safe, NO ethanol is a bonus.
  7. Replies
    27
    Views
    428

    Besides the emission reduction hoax of ethanol....

    Besides the emission reduction hoax of ethanol. Ethanol has less BTU, so it packes less of a punch per combustion event. This means less mileage/hours per gal. So more fuel used to do the same amount...
  8. Replies
    2
    Views
    70

    Yes. Some models offer a valve that goes in the...

    Yes. Some models offer a valve that goes in the outlet of their pump. Just take the hose off, put in valve, reconnect hose, done.
  9. Replies
    5
    Views
    108

    A voltage check on the amp while the issue is...

    A voltage check on the amp while the issue is happening, would be great info. And dont leave off the numbers after the dot. Those tenths and hundreds count. Is the amp setup correctly to run bridged...
  10. Replies
    7
    Views
    153

    The KX200.2 wattage is as follows; 50W rms x 2...

    The KX200.2 wattage is as follows;

    50W rms x 2 @ 4 ohm
    100W rms x 2 @ 2 ohm
    200W rms x 1 @ 4 ohm bridged.

    So going from 2 to 4, they all will still receive the same 50W rms that the current...
  11. The wiring and operation of a 1/2/BOTH switch is...

    The wiring and operation of a 1/2/BOTH switch is simple, just takes a little discipline when on the water.

    The switch has a common output. Every load, except the auto-bilge, gets wired through...
  12. Not with a dual bank battery switch in the scheme.

    Not with a dual bank battery switch in the scheme.
  13. Thats why im trying to figure how its now an...

    Thats why im trying to figure how its now an extra.
  14. LOL, Phil is the last guy id ever say is wrong....

    LOL, Phil is the last guy id ever say is wrong. If he posts, it correct. But, I have no worries about having a different opinion. In reality, I doubt you would ever see your two amps spike above a...
  15. Not all they sell is quality.

    Not all they sell is quality.
  16. Yes, I understand is was in the boat originally,...

    Yes, I understand is was in the boat originally, but was it protection and why is it now extra? I ask, because I do not read that an old amp was removed. My concern is that some circuit is now...
  17. Curious how you ended up with an extra breaker.

    Curious how you ended up with an extra breaker.
  18. Replies
    1
    Views
    98

    Are you running both front and rear outputs into...

    Are you running both front and rear outputs into the amp or splitting a single pair and populating the 4 chnl RCA inputs or or just a single pair of RCA and have the amp in 2 chnl mode? You can swap...
  19. I believe its all an Indmar package. 1-1/8 shaft.

    I believe its all an Indmar package. 1-1/8 shaft.
  20. Replies
    7
    Views
    173

    Yes, on both the MC1 and MC2. The MC1 is a...

    Yes, on both the MC1 and MC2. The MC1 is a black-box setup and the MC2 is an all in 1 compact head setup. The MC1 is a large 7"W x like 5" high. the Mc2 is more square, but cant remember the screen...
  21. Replies
    7
    Views
    173

    Check into the MS-BB300R or the RA670. The BB300R...

    Check into the MS-BB300R or the RA670. The BB300R comes with a remote thats the same as on your transom, so just needs a filler trim plate to fit it in the spot as the 205. I have not compared the...
  22. No, it will not damage anything, you just wont...

    No, it will not damage anything, you just wont hear the full potential of the speakers, until you upgrade the amp.
  23. Hate to break it to you, but any way you slice...

    Hate to break it to you, but any way you slice it, that amp is only going to deliver 150W rms for each pod.

    Parallel would get you a 2 ohm load at the amp, but you cannot bridge a 2 ohm. Series...
  24. Replies
    24
    Views
    1,557

    Every head unit has an on-board amp. it has too,...

    Every head unit has an on-board amp. it has too, or it would not be able to drive a speaker. Totally separate discussion from wanting in-boats and woofer on 1 zone and tower on 2nd zone.

    There is...
  25. Replies
    24
    Views
    1,557

    @jimmsch 1st want to confirm which model head...

    @jimmsch

    1st want to confirm which model head you have. 2nd, its important that ALL speakers be driven by an external amplifier.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4