Search:

Type: Posts; User: Engine Nut

Page 1 of 6 1 2 3 4

Search: Search took 0.07 seconds.

  1. ' The 556184 Pierburg pump is available ... we...

    '
    The 556184 Pierburg pump is available ... we have several hundred in inventory. We did have a supply issue with the Pierburgs last summer but that issue has been resolved.
  2. Replies
    40
    Views
    1,650

    [QUOTE=Bean;306311]I've tried dealer and both...

    [QUOTE=Bean;306311]I've tried dealer and both bakes and ski dim they both are telling me that the part is not available through indmar that I have to get it from the parts store but the one at the...
  3. Replies
    40
    Views
    1,650

    The fuel pump safety switch and the v-drive...

    The fuel pump safety switch and the v-drive switch work opposite of each other. The fuel pump switch is closed when the engine is running and there is oil pressure which allows the fuel pump to run....
  4. 11 lb. ft. is the magic number per the GM service...

    11 lb. ft. is the magic number per the GM service manual.
  5. If your engine dose not have catalytic converter...

    If your engine dose not have catalytic converter exhaust, I would recommend using conventional AC/Delco MR43LTS plugs gapped at .045.. Any catalyst engines should use platinum or iridium plugs. The...
  6. Replies
    15
    Views
    708

    The sensors behind the catalytic converters on a...

    The sensors behind the catalytic converters on a 2008 model are post catalyst temperature sensors. not oxygen sensors. The post cat sensors proved to be problematic and since they were not required...
  7. I assume this is a 5.7L engine ... correct? When...

    I assume this is a 5.7L engine ... correct? When you say overheating, how hot is it getting? Is it setting off the alarm? Remove the cap from the overflow bottle and let the engine run till the...
  8. Replies
    27
    Views
    1,987

    You really need to get with someone that has a...

    You really need to get with someone that has a scan tool. ROM limited to 2000 might just be an issue that is causing the ECM to limit the RPM to avoid damaging something.

    You have a throttle by...
  9. Replies
    2
    Views
    339

    The Indmar P/N for that dipstick is 903064. Any...

    The Indmar P/N for that dipstick is 903064. Any Indmar dealer can order one for you.
  10. Replies
    10
    Views
    750

    We use a wire reinforced hard-walled hose on the...

    We use a wire reinforced hard-walled hose on the suction side of the system to make sure that it does not get sucked flat by the raw water pump. Our P/N is 845004. It is sold by the foot. Your...
  11. Replies
    10
    Views
    750

    If you close the sea cock at the water inlet, the...

    If you close the sea cock at the water inlet, the raw water pump will pull anti-freeze into the system and push it through the raw water side of the engine's cooling system. We would recommend...
  12. Replies
    7
    Views
    498

    If there is a chance of going below freezing , I...

    If there is a chance of going below freezing
    , I would not take a chance. There are only 4 drain points on the engine ... the line that goes from the raw water pump to the heat exchanger, the heat...
  13. Replies
    7
    Views
    498

    Anti-Freeze Protection Levels

    The new Raptor Engines are equipped with what is commonly referred to as a "half closed cooling system". This means that the engine block (including the heater) is cooled by anti-freeze and the...
  14. Thread: Spark Plugs

    by Engine Nut
    Replies
    15
    Views
    2,310

    Spark Plugs

    Here is the scoop on spark plugs. If you have a 5.7L engine that has catylitic converter exhaust (2007 or newer Assault 340) use the platinum (AC 41-932) or iridium plugs (AC 41-101). If the engine...
  15. Replies
    2
    Views
    888

    The Indmar P/N is S903004S.That switch is not a...

    The Indmar P/N is S903004S.That switch is not a GM part. It comes from Walter Machine,the manufacturer of the V-drive.
  16. Replies
    2
    Views
    581

    I'm guessing you have a bad drive plate.The drive...

    I'm guessing you have a bad drive plate.The drive plate bolts to the flywheel and the transmission plugs into it.
  17. Replies
    6
    Views
    791

    Your transmission is a ZF 45C not a Velvet Drive....

    Your transmission is a ZF 45C not a Velvet Drive. Just stopping like that makes me think it may be a drive plate issue. The drive plate bolts to the flywheel and has a female spline in the center...
  18. Replies
    4
    Views
    949

    What year is your boat and what model engine you...

    What year is your boat and what model engine you have?
  19. Replies
    20
    Views
    1,994

    It is probably not the belt but you can verify it...

    It is probably not the belt but you can verify it by taking the belt off and taking the boat out and run it at the RPM where the noise occurrs. Running for a few minutes without the belt isn't going...
  20. Replies
    9
    Views
    982

    The fuel pump on a carb engine does not come on...

    The fuel pump on a carb engine does not come on with the ignition. It works only when the engine is either cranking or running. It gets its power during cranking from the starter solenoid and when...
  21. Replies
    3
    Views
    579

    The first service should be done not sooner than...

    The first service should be done not sooner than 10 hours and not more than 20 hours. If you have 13 hours, that is a good timeto get that first service done.
  22. Replies
    7
    Views
    912

    The fitting with the .010 orifice in it is P/N...

    The fitting with the .010 orifice in it is P/N S601040. Your dealer should be able to order one for you.
  23. Replies
    12
    Views
    1,145

    Indmar has a remote oil filter kit that is pretty...

    Indmar has a remote oil filter kit that is pretty nice. The filter head and adapter that attaches where the current oil filter is are all made of aluminum billett. The part number is S495145. It uses...
  24. Replies
    12
    Views
    1,145

    Indmar has a remote oil friler kit that is pretty...

    Indmar has a remote oil friler kit that is pretty nice. The filter head and adapter that attaches where the current oil filter is are all made of aluminum billett. The part number is S495145. It uses...
  25. Replies
    7
    Views
    912

    You can leave the hose that connects the two...

    You can leave the hose that connects the two manifolds and just cap off the fitting that goes to the dripless packing. Then run the hose that comes from the dripless packing to the fitting on the...
Results 1 to 25 of 128
Page 1 of 6 1 2 3 4