Search:
Type: Posts; User: jzelt
Search: Search took 0.03 seconds.
-
05-27-2021, 01:22 PM
Thread: Hard To Steer
by jzelt- Replies
- 11
- Views
- 5,872
Pull the screws 4 per corner per section. This...
Pull the screws 4 per corner per section. This will give access to the cables/gas tank. Tie a heavy string to the end before pulling thru so that you can use it to fish the new cable back. (used...
-
05-27-2021, 01:12 PM
Thread: Water in Oil - Resolved!
by jzelt- Replies
- 2
- Views
- 788
Thanks for this. I went from plunger fake lake to...
Thanks for this. I went from plunger fake lake to putting the hose in a bucket, fill it and run ~1" hose to the v-drive. I figure this also gives me accurate reading on the impeller capability, makes...
-
We are the third owner. Had 416 hrs when we got...
We are the third owner. Had 416 hrs when we got it 10 yrs ago. We used to be on it april thru mid oct. Last 2 yrs it has been june thru oct.
Sent from my SM-G930V using Tapatalk -
07-27-2020, 03:20 PM
- Replies
- 4
- Views
- 1,299
Agree, based on past posts, I believe they sink....
Agree, based on past posts, I believe they sink.
I have 2004 Supra and could get you some dimensions/pics if you need them to replicate.
... -
1208 this weekend. Rolled over 1200 last weekend.
1208 this weekend.
Rolled over 1200 last weekend. -
07-27-2020, 08:12 AM
Thread: 2004 xlv engine configuration pictures
by jzelt- Replies
- 15
- Views
- 3,414
Water hose from bottom of the boat goes to port...
Water hose from bottom of the boat goes to port side of vdrive. Starboard side goes to lower intake on the water pump. I have a water filter in between pickup and i would recommend putting a shutoff...
-
06-09-2020, 12:01 PM
Thread: Trailer Bunks
by jzelt- Replies
- 19
- Views
- 2,526
I cut and pre-carpet the bunks ahead of time at...
I cut and pre-carpet the bunks ahead of time at home. I launch and spend some time on the water. Go back to the parking lot after it has had some time to dry. Cordless drill pre-drill holes and run...
-
06-09-2020, 11:09 AM
Thread: 2004 xlv engine configuration pictures
by jzelt- Replies
- 15
- Views
- 3,414
Rear hatch = yes. Similar thickness to the black...
Rear hatch = yes. Similar thickness to the black parts sticking out the side of you cubby in this pic I believe. When I rebuilt our Chaparral engine hatch, I used 1/2" plywood and put fiberglass...
-
06-09-2020, 10:56 AM
Thread: Maintenance behind engine?
by jzelt- Replies
- 10
- Views
- 1,998
Your packing nut may drip (nut on driveshaft by...
Your packing nut may drip (nut on driveshaft by your pvc pipe). It looks like you may be out of adjusting it tighter based on the pic.
A set of hook picks work great for getting the old out. A... -
06-10-2019, 09:27 PM
Thread: Boat stalling when going from idle to WOT
by jzelt- Replies
- 4
- Views
- 1,927
I have replaced throttle position sensor. $35...
I have replaced throttle position sensor.
$35 chevy suburban 5.7L 1999 or so year if you have throttle body.
My symptom was black (rich) exhaust and high idle at neutral as well as hesitation and... -
10-04-2018, 09:40 PM
Thread: Question on the Fulton Jack..
by jzelt- Replies
- 7
- Views
- 1,598
Replaced mine this summer directly by removing...
Replaced mine this summer directly by removing the nut with Fulton Xlt Jack from e trailer.
Night and day difference with grease fittings built in.
I did get the replacement gears to rebuild the... -
08-26-2018, 09:49 PM
- Replies
- 6
- Views
- 1,631
If you look at the throttle cable in the back...
If you look at the throttle cable in the back (starboard side) you should be able to disconnect the cable by sliding the link toward the bow and pop it off.
Sent from my SM-G930V using Tapatalk -
07-19-2018, 10:15 PM
Thread: EFI - Rich fuel mixture
by jzelt- Replies
- 3
- Views
- 2,577
I would swap throttle position sensor. Did that...
I would swap throttle position sensor. Did that on my Supra. Same year. 99 chevy 5.7L part from autozone did it for me.
Sent from my SM-G930V using Tapatalk -
12-13-2017, 03:44 PM
Thread: Winterizing - what to do with batteries
by jzelt- Replies
- 27
- Views
- 7,099
Perko Switch is off. I hook up battery charger to...
Perko Switch is off. I hook up battery charger to both at end of season to make sure they are at capacity. Then hook up Harbor Freight $5 trickle charger to it. Switch to snowmobiles the same process...
-
08-15-2017, 04:11 PM
Thread: August 2017 Picture Thread
by jzelt- Replies
- 124
- Views
- 26,907
Son just turned 6 on Sat. Took some coaxing from...
Son just turned 6 on Sat.
Took some coaxing from us to get him to ride with us, but once he did he was all smiles.
Has been riding double with me or wife since he was 4. (15-18 mph).
I was... -
02-16-2017, 06:00 PM
Thread: Running engine while on trailer
by jzelt- Replies
- 18
- Views
- 6,132
The issue I don't like with the Fake a...
The issue I don't like with the Fake a lake/plunger is if you are in the boat and move around, that bounces the trailer. I haven't lost connection with the plunger but went with a setup using a hose...
-
02-13-2017, 04:33 PM
- Replies
- 17
- Views
- 41,602
You probably shouldn't have asked "Wonder how far...
You probably shouldn't have asked "Wonder how far he'll fly if I treat him like a Water Balloon.
We had boat toys (boats, turtles, etc). Had his life jacket on all the time and even sat on the...
Results 1 to 17 of 17