Search:

I am not sure if its the same hull, but I have a 2000 mobius V. I run two 540 lb custom sacks from wake makers in the back and a 550 fat sack in the middle locker, and can surf just fine (with a...

Thanks! Cecil hooked me up right away. Great guy, good prices.

I need a prop Shaft for a 2000 moomba mobius v. It's back order ed from factory. Any ideas?

Thought I would pass this information along:

The bearings for the pump are 6203RS, and can be found at the local bearing supply.

OK, so the rudder shaft is bent slightly and is rubbing on the mount on the underside of the boat when turned one direction. Should it be straightened, or can a relief be cut into the top of the...

Thanks, It looks like my rudder shaft may be bent slightly.

25396
Where the black nut meets with the housing with the 4 bolts. The nut is tight as is the bolt just visible on the back of the AL mount. I do not know if it is supposed to allow the mount with...

Is this mount supposed to be loose to allow for movement of the cable? It is not loose at the floor, just where the black nut attaches to the aluminium mount.

25385

Thanks Scott.
Mine must just be a standard harness on with plugs for both the injected model and carb model.

Scott,
Do you know if this is only used on carbed models (my old 4.3 had same looking plug that was connected)? Current 5.7 is injected, and the harness is unplugged. Engine runs.

2000 Moomba Mobius LSV - PCM apex 5.7 MPI25357