Search:

Type: Posts; User: jroberts

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    6
    Views
    1,555

    I see that this is a recommended prop for my '07...

    I see that this is a recommended prop for my '07 Supra 22SSV when it is heavily weighted... Do you know the downsides when it is NOT heavily weighted? Lower top end speed?

    Thanks
    Jeff
  2. A couple of weeks ago I noticed that there was a...

    A couple of weeks ago I noticed that there was a lot of water in the boat when I pulled out and took out the drain plug. The first thing that I found was that my bilge pump was not working. The...
  3. Replies
    5
    Views
    3,714

    You can do a system reset by holding down a...

    You can do a system reset by holding down a couple of the buttons while the unit powers up. I think that it is the on/off and the ^, but check the online manual to be sure.
  4. Replies
    4
    Views
    1,636

    Mine was the sahara S500 as well. I finally...

    Mine was the sahara S500 as well. I finally yanked on it until it came apart. There was a small lever that pushed in and acts as a release, but it still took some determination to separate the two...
  5. Thread: O5 Lsv Cover

    by jroberts
    Replies
    11
    Views
    3,171

    Is this the same hull as an '04 LSV then? I was...

    Is this the same hull as an '04 LSV then? I was thinking that the change occurred between '04 and '05.
  6. Replies
    4
    Views
    1,636

    Gray Electrical connector

    Hey guys, I'm replacing my bilge pump, and it is wired to some sort of small gray electrical connector that looks like it should just come apart, but won't. Anyone know the secret words or...
  7. Replies
    22
    Views
    6,235

    My transducer came loose and slid around until it...

    My transducer came loose and slid around until it lodged under a hose, and it was tough to find as well. I had the same symptoms as many of you: it would work erratically and unpredictably. If I...
  8. Replies
    8
    Views
    3,373

    I have a yellow '03 LSV, and Tazz's would not fit...

    I have a yellow '03 LSV, and Tazz's would not fit mine. I'm still looking too.
  9. Replies
    54
    Views
    11,043

    For those of you who have asked how this turned...

    For those of you who have asked how this turned out, I want to apologize for not posting the conclusion sooner. But, I wanted to get some time between the emotion and my final comment.

    In short,...
  10. Replies
    2
    Views
    1,138

    Yes, but how does the bracket come off? Does it...

    Yes, but how does the bracket come off? Does it detach from the impellar housing somehow, or the other end?
  11. Replies
    2
    Views
    1,138

    03 Mob LSV; Replace Belt?

    Any tips on replacing the alternator belt on my '03 Mobius LSV? There is a bracket on the left side that attaches to (through?) the bottom of the impeller housing, and we can't figure out how to get...
  12. Replies
    4
    Views
    1,470

    I had some problems with a dealer in my area...

    I had some problems with a dealer in my area earlier this year. The thread is on this board, so I won't revisit the ugly details here. But "Mob" was involved with that as well. I thanked him once...
  13. Replies
    3
    Views
    1,132

    This is one of those recurring problems that is...

    This is one of those recurring problems that is posted here quite often. In most cases it is caused by water entering the steering cable where it connects to the rudder. It seems that this is the...
  14. Replies
    4
    Views
    1,797

    Solution

    For posterity's sake, we found the answer to the issue with the oil pressure. My auto mechanic hooked up another pressure gauge and discovered that the actual pressure was fine. He also cleared the...
  15. Replies
    4
    Views
    1,797

    The dealer changed the oil at the end of the last...

    The dealer changed the oil at the end of the last season.... we've had the boat out three times since then. I wonder why an oil change would fix that?
  16. Replies
    4
    Views
    1,797

    Low oil pressure?

    At idle, my oil pressure is fine (around 40). In reverse, my oil pressure is fine. Once I start going forward, the pressure goes to practically zero and stays there until I get around 22 or so,...
  17. Replies
    5
    Views
    1,307

    I have also had to replace mine twice. What I...

    I have also had to replace mine twice. What I have learned is that it is very difficult to get all of the water out of the bilge, and the lowest point of the boat seems to be where the cable mounts...
  18. Replies
    54
    Views
    11,043

    I totally missed the owner’s response from the...

    I totally missed the owner’s response from the 7th when I posted my last.

    So, from my standpoint there are 2 issues:
    1) What happened to my boat
    2) The response that I received when I tried to...
  19. Replies
    54
    Views
    11,043

    I wanted to post a quick reply. things have been...

    I wanted to post a quick reply. things have been pretty busy lately. My wife dislocated her patella on our trampoline, and now I get to be Mr, Mom, chauffeur, etc.

    So, yeah, the winterization is...
  20. Replies
    54
    Views
    11,043

    Thanks for all the responses and PMs, especially...

    Thanks for all the responses and PMs, especially Sandm and Benson. I was hoping that someone would eventually take an oppossing viewpoint. My take on it is this: I know that some people are far...
  21. Replies
    54
    Views
    11,043

    Yes, I hope that's the way it works out too. But...

    Yes, I hope that's the way it works out too. But I don't see a lot of reason to be optimistic. Friday he told me that I could send a check to SC and they would arbitrate for us. If I agreed, he...
  22. Replies
    54
    Views
    11,043

    Kaneboats, Yes, if I had it to do over, that is...

    Kaneboats,
    Yes, if I had it to do over, that is certainly what I would do. I tend to be the old fashioned type that doesn't carry his lawyer's card around in his shirt pocket, but I'm learning. ...
  23. Replies
    8
    Views
    2,411

    Yes, there should be an existing loop in the end...

    Yes, there should be an existing loop in the end of the line. Reach your hand through that loop and grab the line. Then pull the line back through the original loop. Use that 2nd loop to attach...
  24. Replies
    54
    Views
    11,043

    Thanks everyone for your advice and your support....

    Thanks everyone for your advice and your support. I wrote a couple of letters to our Regional Sales Representative, and one to RickT, the admin of the board. They never replied, but the dealer in...
  25. Replies
    54
    Views
    11,043

    There is no way that these folks are going to...

    There is no way that these folks are going to step up to anything. This is part of an email that I just received:

    "As we discussed, the boat was removed from our facility without our knowledge...
Results 1 to 25 of 38
Page 1 of 2 1 2