Search:

Type: Posts; User: Brian Raymond

Page 1 of 14 1 2 3 4

Search: Search took 0.08 seconds.

  1. Replies
    26
    Views
    4,150

    Aaron, hope all is well. I would stay with the...

    Aaron, hope all is well. I would stay with the o.e.m. spark plugs (MR43LTS), and gap them @ .030. They can be purchased and drop shipped from your dealer, or purchase them from Indmar (901.953.3350)....
  2. Replies
    4
    Views
    1,313

    The above statements are correct. To ensure long...

    The above statements are correct. To ensure long lasting reliability and minimal running issues, be sure to stabilize the fuel in the tank, and run for a bit when winterizing. Brian Raymond
  3. Replies
    10
    Views
    2,545

    Great job, I love to hear about happy endings....

    Great job, I love to hear about happy endings. Brian Raymond
  4. Replies
    3
    Views
    1,146

    Pete, hope all is well. I am sorry to hear of...

    Pete, hope all is well. I am sorry to hear of your issue. What year and model is your boat? The system is self bleeding, the proper way to check fluid level is with plate all the way up to ensure the...
  5. Replies
    4
    Views
    1,423

    The break in fluid changes are very important,...

    The break in fluid changes are very important, these initial changes discard the metallic residue from the new materials wearing together. The transmission has several single pressure plates that...
  6. Replies
    1
    Views
    793

    Sorry to hear about the mishap. The pro. for your...

    Sorry to hear about the mishap. The pro. for your boat is a 13x13 left hand with a 1" bore (shaft size). Hope this helps. Brian Raymond
  7. Replies
    1
    Views
    1,021

    Do you have Perfect Pass? It sounds like the...

    Do you have Perfect Pass? It sounds like the servo cable is to tight, and when the engine is turned off, the servo goes to reset and your idle is okay. Also, check to see that your linkage is...
  8. Replies
    2
    Views
    1,634

    It is a Johnson pump. There is a impeller repair...

    It is a Johnson pump. There is a impeller repair kit available, it includes a impeller, gasket, and seal that installs in the back of the raw water pump. The Indmar part # for this kit is 495001,...
  9. Replies
    1
    Views
    1,268

    Alex, hope all is well. All direct drives use the...

    Alex, hope all is well. All direct drives use the 1/4" packing, all V-drives use the 3/16" packing. If you are not familiar with the install and tightening procedure, you can contact;...
  10. Replies
    3
    Views
    1,433

    First, check the grounds. There may be some...

    First, check the grounds. There may be some corrosion between the terminals. First, remove the batt. gnd. cable at the engine block, clean and grease the surface. unplug the engine harness and check...
  11. Replies
    10
    Views
    3,833

    The props (when new or recon.) are pretty close,...

    The props (when new or recon.) are pretty close, the diff. you will feel in the 4 blade is; a better hole-shot, 2-300rpm increase with a 1/2- 1mph top end decrease, some say it is smoother, others...
  12. Replies
    8
    Views
    1,678

    The Walters V-drive uses SAE 30 only, Indmar...

    The Walters V-drive uses SAE 30 only, Indmar reccomends Pennzoil, but if not available, a good name brand oil will suffice. The Hurth transmission uses Dexron III trans. fluid. Brian Raymond
  13. Replies
    2
    Views
    1,473

    The fuel filter is a Carquest brand #86299, or...

    The fuel filter is a Carquest brand #86299, or Wix # 33299. It should be replaced every season. The fuel/water separators are not really needed, Skiers Choice stopped useing them in 2000. There were...
  14. There is no sensor on the tach, it receives its...

    There is no sensor on the tach, it receives its signal from the coil. I would venture to say, that, if the connections are clean and tight, the switches in the proper positions, you may need a new...
  15. Replies
    9
    Views
    3,215

    The E-Z cruise is only available on the '06 and...

    The E-Z cruise is only available on the '06 and '07 model Moombas. This is due to the updated electronics on the fuel injected motors with cable assisted throttle by wire only. This is a nice...
  16. On the backside of the tach, there are 8 mini...

    On the backside of the tach, there are 8 mini switches. These are used to tell the tach what type of motor it is running (4,6,8, cyl). Be sure these switches are in order. For the 8 cyl. application,...
  17. Replies
    7
    Views
    1,867

    There is not a water/fuel separator on the boats....

    There is not a water/fuel separator on the boats. It sounds like the fuel filter may be the bandit here. First, make sure there are no kinks in the fuel feed line or return line from the tank to the...
  18. Replies
    9
    Views
    2,300

    Specify to your dealer that you want OEM...

    Specify to your dealer that you want OEM replacement wires (they can drop ship). You can also contact Indmar @ 901.353.9930 and ask for JT in parts. Be sure to have engine info. readily available....
  19. Replies
    2
    Views
    878

    Pickle, OJ makes a nice 13x11 3blade CNC prop....

    Pickle, OJ makes a nice 13x11 3blade CNC prop. With that kind of load, and you are not wanting top end, I think you will be happy with this one. Keep us posted. Brian Raymond
  20. Replies
    2
    Views
    1,192

    Replying to Topic 'No hot water coming out of shower'

    Rugburn, if your hot water supply is coming from the block, you may have some debris (dirt,rust,sand) build up in there, and it is letting little water through to the valve but with no pressure....
  21. Replies
    10
    Views
    3,908

    Replying to Topic 'fuel pump problem'

    Jrrrr, hope all is well. There is a 3 prong oil pressure/fuel pump switch just port and under the distributor. It is a safety device threaded into a oil pressure port. There is a Orange (batt),...
  22. Replies
    6
    Views
    1,460

    Replying to Topic ''06 first engine problems'

    Erik, have the dealer check/replace the fuel filter. When these get full of crud, it can lean the motor out and cause popping at higher rpms., yet run okay mid range. Looks like ya got 'er licked on...
  23. Replies
    1
    Views
    835

    Replying to Topic 'Where can I get an

    Rick, click on "library" at the top of the screen, there are files of owners manuals back to 2002. That manual should not differ much from '01. Older manuals are being added, check periodically....
  24. Replies
    3
    Views
    1,056

    Replying to Topic 'Plug wires and distributor'

    I would stay OEM, especially when dealing with electrical and fuel components. By replacing with OEM parts, you can be assured that those items meet all the proper specs. for marine application....
  25. Replies
    6
    Views
    1,209

    Replying to Topic 'Carb or EFI Cleaners'

    I know that Indmar has done testing with Sta-bil only. The other fuel additives and cleaners are not recommended. Brian Raymond
Results 1 to 25 of 337
Page 1 of 14 1 2 3 4