Search:

Not much, I add cupping to keep the RPM down with the smaller diameter.

Brain, I have not heard back from Robert regarding his prop mod's. I can say that when I tested a 14.25 X 14 that I cut to 14" the noise issue was reduced on the LSV, not eliminated but reduced. We...

2010 and 2011

I understand what you are saying and appreciate your thoughts. The OJ FUSION is the standard prop for both SUPRA and MOOMBA, Skiers Choice made a good choice there. Choice was made after testing all...

Could have been installed that way. The props are water tested at the plant and then put back in the box to ship with the boat. If there is a vibration issue at water test we would get the prop back....

When the prop is difficult to remove from the shaft it is an indication the propeller was not seated correctly to the taper of the shaft, which can cause vibration from an improper fit.

Feel free to give me a call and we can work something out. 800-359-9730

Would have like to checked it prior to being repaired.

I can cut the diameter down to help reduce the noise.

You da man - Do you still have the prop?

The 13.7 X 17.5 would cavitate more under load than a larger diameter prop, making a vibration noise/feel. The correct size for the application makes a difference.

The noise issue on the LSV's is due to the 14.25 diameter of either the Fusion or the XMP. When a prop with 14" or less is used the noise is reduced. The OJ PROPS in general do not have a vibration...

None taken. Anything over 14" in diameter on a newer LSV will make noise.

Give me a call - 800-359-9730 and we can take a look at the prop.

The Sanger boats use the 1:1 transmissions and will run the lower pitch 3-blades.

If it is dripping in the boat then the seal itself is damaged. The seal can be replaced and the motor would need to be aligned.

If the water was coming out of the shaft log, outside of the boat, it is because the seal system is water lubricated from the motor. Water is pumped to the seal and exits through the log down the...

Jay was a great guy with great sense of humor and knew his boat stuff, will be missed. From all of us at OJ PROPS.

Razz - Thanks for getting the ball rolling on that one.

That was the B-Day prop for the husband. Good to hear it worked out well for them.

[QUOTE=jester;99920]Eric,

About how many days does it take once the prop hits your loading dock?



No more than two days in the shop. Most go out the same day.

Standard ground shipping via Fed Ex would be no more than $15.00. To send one next day air runs $45 to $50.00.

Keep in mind as well, we are the only factory that does repairs in house.

The cost for a typical repair we do runs from $70.00 to $150.00. Most fall between $80.00 and $100.00. The $260.00 for a repair is very high. We do all repairs in house and will not attempt a prop we...

There is also an increase in diameter on the Acme of 1/2". On "paper" the two props are the same size and should produce like RPM numbers, relative to cupping as well, or very close numbers.

A difference in pitch of a 1/2" should not lower RPM by much if any. Would guess it would run close to the same MPH/RPM as the current prop.