Search:

Type: Posts; User: pecanflyboy

Search: Search took 0.02 seconds.

  1. Replies
    6
    Views
    2,230

    When I pulled the hose off of the OUTLET side of...

    When I pulled the hose off of the OUTLET side of the transmission cooler, the screen was full of rubber debris. When the impeller fails, most of the debris flows back to the transmission cooler as...
  2. Replies
    6
    Views
    2,230

    Good call on the transmission cooler. I had to...

    Good call on the transmission cooler. I had to go to Texas Mastercraft to get the thermostat kit, and that's exactly what the tech said. I guess parts can back flow to the trans cooler.

    He...
  3. Replies
    6
    Views
    2,230

    I did see that, but not much info. I spoke...

    I did see that, but not much info.

    I spoke with a mechanic today. He said the computer was cutting out my engine to protect it during the overheat. So, I feel that I probably did not hurt the...
  4. Replies
    6
    Views
    2,230

    Impeller debris in engine, 2001 Mobius

    I overtemped my motor today, because the impeller died. I couldn't get the RPM's much over idle, and when I finally realized it was overheating, the guage was pegged at 240. Removed the hoses,...
  5. Who makes the Moomba towers?

    Who makes the Moomba towers?
  6. Right now, there is a piece of PVC installed over...

    Right now, there is a piece of PVC installed over the pylon. I was hoping to find a machined delron or nylon that would fit over it.

    J
  7. Replacement swivel for tower rope attachment.

    I've got a 2001 Mobius with the OEM tower. The rope attachment pylon does not have a plastic or delron pivot. Is there a swivel available for purchase that can be installed on over the tower rope...
  8. Replies
    3
    Views
    1,896

    Problem solved. Found an Indmar service...

    Problem solved. Found an Indmar service representative that told me that the open port is for diagnostics, and not used for the oil pressure switch. Apparently, when the diagnostics tool in used...
  9. Replies
    3
    Views
    1,896

    Oil pressure switch missing?

    Hey everyone,
    I just bought a 2001 Mobius. The engine was replaced with a crate marine engine last year. While going over everything, I noticed that the hole above the oil pressere sender is...
  10. Replies
    3
    Views
    1,027

    Thanks Al, I realize this may be the case. I'd...

    Thanks Al,
    I realize this may be the case. I'd like to find one with fittings at both ends. If not, I'll just have to run the line down the side of the tube.

    I'd like to find a new one at Fat...
  11. Replies
    3
    Views
    1,027

    WTB: 10"x16"x70" fat sac or ballast bag

    Looking for a 10"x16"x70" fat sac or ballast bag that is in excellent condition. I have a 2001 Mobius, and this sac should fit under the rear seat. Please email me directly at [email protected]
    ...
  12. Thanks. The 70" length sounds right. Where is a...

    Thanks. The 70" length sounds right. Where is a good place to find these bags used? eBay? Here?
  13. 2001 MOBIUS fat sac ballast bag replacement

    Hello everyone,
    I have a 2001 Mobius, direct drive. When I purchased the boat, the pump and switches were installed for a under rear seat ballast bag, but the bag was gone. I want to replace this...
Results 1 to 13 of 13