Search:

Simplest solutions are usually the best. Found a breaker switch right beside the battery box behind the observer seat. Just reset that breaker and the problem was solved. Breaker looks like this:...

Digging through the forum and this post just solved my problem as well. Breaker was right next to the battery behind the observer seat. Reset that breaker and problem was solved! Thanks for...

2007 Outback V....Pulling the boat out for the first time this year and battery seems to be good (registering 12.5 volts at the terminals). Follow that back to the starter solenoid and still getting...

I have had some of the same issues. Have you replaced the temp gauge sensor? It just screws in to the block and is relatively inexpensive on skidim.com. That might be the issue.

Thats kind of what I have been assuming. Cooling system seems pretty straightforward. Thinking I will replace the thermostat at this point. As you mentioned, its not an overly expensive part and...

My temp gauge on my 2007 Outback V was going in and out but when it functioned it seemed to indicate that temp was on target in center of the gauge at 160 degrees. I just replaced the sending unit...

Quick update on this. I went over most of the hoses and found that the raw water pump to transmission oil cooler hose was also in bad shape. Both hoses seemed to fail at the curves and both are...

I was speaking with Discount Inboard Marine about my sensor and they mentioned that a quick test to determine if the sensor was bad was to turn the key so you have power to the dash then remove the...

Was out this weekend and boat power stuttered briefly, looked back and bilge was running. Found that my hose running from circulating pump to thermostat housing (J shaped hose about 12" long) had...

I'm replacing mine right now and am stuck at line 15......15. Use the pry bar to remove the trailing arm from the axle. (NOTE: This is a lot of work and you might have to keep using the pry bar to...

Anybody have any tricks to getting trailing arms off of the axle? Have pulled off the caliper, fender and gotten the trailing arm bolt out but can't get that thing to move at all. Have hammered a...