Search:

Type: Posts; User: Branden967

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    29
    Views
    1,389

    Great point, I refuse to buy one. That is until...

    Great point, I refuse to buy one. That is until I win the lottery.
  2. Replies
    37
    Views
    2,023

    With all those toys I wouldn’t make that a...

    With all those toys I wouldn’t make that a priority either! Where’s the sleds?
  3. Yep the engine was off when I check it. I didn’t...

    Yep the engine was off when I check it. I didn’t read the dipstick before I sucked out the old. I just set to change it as it was new to me and I like to log it etc.
  4. I just bought the boat, I ran it till it was...

    I just bought the boat, I ran it till it was warmed up and sucked out 3 quarts. Sorry I meant the dip sticks reads about a 3/4 of an inch above the dots.

    Is 5 quarts the “average” of oil back in...
  5. Assault 325 Oil Capacity vs dipstick level?

    Hey Guys,
    I feel kinda of dumb for asking this....but I need some advice here. I have a 07 Outback V, with the Assault 325 motor and Im doing the oil changes myself. The manual says that that...
  6. Replies
    9
    Views
    392

    One guy posted on here a while back about using a...

    One guy posted on here a while back about using a air tool line quick disconnect connector on the end of the drain line, then attaching that to your suck tube. I tried it, it worked ok, it kept...
  7. Me too! Dont just tease us...

    Me too! Dont just tease us...
  8. Replies
    11
    Views
    367

    The quick-connect part is leaking on almost all...

    The quick-connect part is leaking on almost all my fittings. Im surprised there isnt a washer replacement kit....
  9. Replies
    144
    Views
    8,630

    Are you guys using the side wake plates to get...

    Are you guys using the side wake plates to get the wake that smooth or is that all just ballasts?
  10. Replies
    11
    Views
    367

    I like the Vaseline idea....When you did the...

    I like the Vaseline idea....When you did the silicone, was it a pain to remove it?
  11. Replies
    11
    Views
    367

    I was planning on keeping the stock bags for now,...

    I was planning on keeping the stock bags for now, Im getting a pretty consistent drip. Maybe a couple of 4 quarts at the end of the day.

    I dont really want to glue them all up, incase I needed...
  12. Replies
    11
    Views
    367

    Ballast fitting leaks?

    Hey Guys,
    I have a 08 outback v with a stock ballast system. The kiddos are finally interested in surfing and I filled them up for the first time and it seems like every quick connect fitting...
  13. Replies
    146
    Views
    10,179

    Sweet idea and thanks!

    Sweet idea and thanks!
  14. Replies
    146
    Views
    10,179

    I have that same tower, what are you using to...

    I have that same tower, what are you using to hold the boards down on the top of it so they lay flat? Could you send me a pic, I like that idea.
  15. Replies
    8
    Views
    465

    Are you sure a 160 degree thermostat was put back...

    Are you sure a 160 degree thermostat was put back in? If it’s not going above the 180 mark, was a 180 thermostat put in by mistake?
  16. Replies
    10
    Views
    577

    I second a fuel issue. Does it run fine up to...

    I second a fuel issue. Does it run fine up to 4000 RPM and then cut out after? If so sounds like it’s starving for fuel. Have you also checked the fuel filter?
  17. Replies
    147
    Views
    11,110

    Uh oh....wife pissed at the back of the boat and...

    Uh oh....wife pissed at the back of the boat and no truck? That sucks!
  18. Replies
    44
    Views
    7,820

    Thanks for info. Its weird because my pump runs...

    Thanks for info. Its weird because my pump runs I even ran the boat for a little bit to get it primed. The other bags filled up, just not the center (which is the one I put new valve on. ) Maybe I...
  19. Replies
    44
    Views
    7,820

    Hate to dig up an old thread..... Please dont...

    Hate to dig up an old thread..... Please dont flame me....

    Does it matter which wire on the solenoid goes to what? Im having the same issue described on this thread, I replaced my valve...
  20. Replies
    44
    Views
    7,820

    Hate to dig up an old thread..... Please dont...

    Hate to dig up an old thread..... Please dont flame me....

    Does it matter which wire on the solenoid goes to what? Im having the same issue described on this thread, I replaced my valve...
  21. Replies
    30
    Views
    1,798

    That sounds interesting, I’d like to see the pics...

    That sounds interesting, I’d like to see the pics on that.
  22. Replies
    57
    Views
    4,997

    Great info there. +1 on choosing your guest...

    Great info there. +1 on choosing your guest wisely....I look at every day trip as an interview for the house-boating trip. Spending a day on the boat is one thing....a week in close quarters on a...
  23. Replies
    14
    Views
    680

    The guy in the background in the water is...

    The guy in the background in the water is priceless. You know he’s thinking “let’s get this s*^t started”!
  24. A quick suggestion, I had those sample amps and...

    A quick suggestion, I had those sample amps and mine were overheating and tripping off. Someone threw a blanket in there on them and they tripped off. There’s some type of over heat protection. Just...
  25. Replies
    23
    Views
    2,495

    Heres a link to the stuff I used; ...

    Heres a link to the stuff I used;

    https://www.amazon.com/gp/product/B003HIV3BM/ref=ppx_yo_dt_b_asin_title_o07_s00?ie=UTF8&psc=1

    I mainly hit the metal fuel line in and around the block. Do...
Results 1 to 25 of 32
Page 1 of 2 1 2