Search:

Type: Posts; User: zabooda

Page 1 of 20 1 2 3 4

Search: Search took 0.07 seconds.

  1. Replies
    59
    Views
    5,770

    If the no wake zone is there to protect boats at...

    If the no wake zone is there to protect boats at the dock then the responsible organization needs to move the buoys out further.
  2. Replies
    25
    Views
    844

    Nothing rocket science about Evolution covers but...

    Nothing rocket science about Evolution covers but that area does have one of the highest labor rates in the country. Find a local boat cover maker and save some coin.
  3. Replies
    9
    Views
    169

    Possibly a stuck float switch on the bilge pump...

    Possibly a stuck float switch on the bilge pump if all the switches were off, overheated the bilge pump motor when the voltage dropped and then tripped the breaker. Check your bilge pump for any...
  4. Replies
    19
    Views
    530

    Find out who manufacturers the Moomba depth...

    Find out who manufacturers the Moomba depth finder and model number and look on line.
  5. Replies
    8
    Views
    226

    About all I can say is the bow and stern have...

    About all I can say is the bow and stern have some similarities with one being the pointy end.
  6. Replies
    8
    Views
    226

    Here is one.

    Here is one.
  7. If you find it is the blower, check inside the...

    If you find it is the blower, check inside the housing for debris that may have locked it up.
  8. Replies
    12
    Views
    4,226

    It shouldn't. In fact, the pump is off until the...

    It shouldn't. In fact, the pump is off until the oil pressure sensor energizes the circuit.
  9. I stayed there once at a friends home some years...

    I stayed there once at a friends home some years ago. Busy lake. Be sure to get the $23 out of state invasive species sticker. I prefer other lakes nearby with Dworshak reservoir at 72 degree...
  10. Replies
    13
    Views
    542

    Great job! Over time, you would expect galvanic...

    Great job! Over time, you would expect galvanic action between the steel and aluminum so this installation could eventually be permanent. The moment arm has now doubled so the maximum force needs to...
  11. Replies
    19
    Views
    707

    Sometimes it's better to say nothing at all.

    Sometimes it's better to say nothing at all.
  12. Replies
    1
    Views
    90

    That would be your local tarp maker or...

    That would be your local tarp maker or upholsterer. Wait until you try looking for parts.
  13. Replies
    7
    Views
    517

    Heckava dock your building. A basic dock with...

    Heckava dock your building. A basic dock with four pylons would get you started and at a price the depreciation on the boat would be.
  14. Replies
    2
    Views
    64

    Starboard side of the engine in front of the rear...

    Starboard side of the engine in front of the rear engine mount. The hose goes under the floor and up behind the gas tank to the rear vent. Not sure where the wires come from.
  15. Replies
    9
    Views
    320

    There is only one right answer if you have to...

    There is only one right answer if you have to travel during high wave action and that first all occupants including the driver don life jackets, snap on the bow cover and drive the boat at a high...
  16. Replies
    3
    Views
    208

    I think you got it with the foam as my boat is...

    I think you got it with the foam as my boat is open bow so I use a full cover.
  17. Replies
    9
    Views
    161

    The 13x13 will give you about 2mph more speed and...

    The 13x13 will give you about 2mph more speed and keep the rpms down. A three blade will be slower out of the hole but higher top end speed than the four blade.
  18. Replies
    1
    Views
    74

    Loose or dirty connection at the gauge or a...

    Loose or dirty connection at the gauge or a broken connection in the wiring to the puck. Try unconnecting the wire to the puck, spray contact cleaner onto both and reconnect.
  19. Replies
    19
    Views
    530

    Only reason I use a depth finder is to go in...

    Only reason I use a depth finder is to go in places where people with depth finders don't go. I'm a smooth water fanatic. When I got my boat, the depth finder was next to the shifter and totally...
  20. Thread: Heater hoses

    by zabooda
    Replies
    15
    Views
    368

    I'm assuming the heater vent hose because getting...

    I'm assuming the heater vent hose because getting holes in your water lines would be no fun. I would go back and get the bad heater vent hoses replaced. It is easy for the installers to get a tear...
  21. Replies
    218
    Views
    11,757

    I used to do that until someone pulled the key...

    I used to do that until someone pulled the key and either tossed it or took it when it was parked at a dock. I had to go all the way home to get a spare so we could do some boating. I now hide a...
  22. Replies
    10
    Views
    283

    Can you use a boat (not saying the Moomba) as the...

    Can you use a boat (not saying the Moomba) as the floating device, tie down the boat to the lift mechanism, crank the lift all the way down causing the lift to be suspended by the boat, move the...
  23. Replies
    9
    Views
    309

    It is hard to compare insurance costs as exchange...

    It is hard to compare insurance costs as exchange rates are different, policies are different and regional pricing is different. I would recommend moving the $2M liability to an umbrella policy that...
  24. Replies
    5
    Views
    140

    Here is some good info: ...

    Here is some good info:


    http://www.trojanbattery.com/Tech-Support/FAQ/BatterySelection.aspx
  25. Replies
    5
    Views
    140

    X2. That is what I have but I don't crank a...

    X2. That is what I have but I don't crank a humongous stereo either nor do I let the boat sit idle for more than a few hours.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4