This would be a good how-to thread if you are up for it. Pictures and part numbers, step-by-step, etc.
Printable View
This would be a good how-to thread if you are up for it. Pictures and part numbers, step-by-step, etc.
The filler neck I got my dealer to order for $60. The hose's and tee's from a local hydraulic supplier. Attachment 17454Attachment 17455Install was easy. Drill practice holes so you get the spacing right. And have a file on hand for the finishing touches. A little bit of weatherproofing foam to fill the void and your done.
Hopefully I get to try it out this weekend. Weather has been shitty up here.
I know already that the factory side is going to be a slow fill but it will be worth it, for me, anyways.
Sent from my iPhone using Tapatalk
Yes it will fill slow because of the tee. I just can't find a 1-1/2" wye fitting anywhere. This was as close as I could get...Attachment 17465 and I wasn't going to go there!
I'll snap some side views this weekend for you. The ridge was fine to go over.
Sent from my iPhone using Tapatalk
For those that fill on the water, right side is key on an inboard, especially when you are the only person on the boat, or in a river with strong currents!