I have all the bolts and screws out, does anybody know of a good way to get that plate removed from the back of the boat? I tried a heat gun to heat up the epoxy and a hammer and that didn’t make it budge. Any ideas?
Printable View
I have all the bolts and screws out, does anybody know of a good way to get that plate removed from the back of the boat? I tried a heat gun to heat up the epoxy and a hammer and that didn’t make it budge. Any ideas?
Plate? Like the wake plate hinge?
Debond spray, scoring the edges, the longer and more spray used the easier it comes off, use some small wood shims to help pry it off slowly after using the debond.
https://marineformula.com/collections/marine-formula
Sorry, the surf plate, I think it’s auto flow? The big block of metal on the transom port and starboard. I’m installing Evolution tabs and want remove those plates.
i would assume they are glued on with 3M 5200....i would get the debond for sure!
I take it you have manual flow tabs now? Or you jist upgrading the autoflow tabs?
Couldn't you jist reuse the hinges if you had autoflow already?