Originally Posted by
cab13367
If you are going to go with just two IX500.4’s, I would go this route:
Amp #1: Run the two bow speakers off two channels at 4 ohms. Wire the 4 cabin speakers in parallel and run them off the other two channels (at 2 ohms).
Amp#2: Bridge two channels to drive the Polk sub at 4ohms. The sub MUST be a 4 ohm single voice coil sub. Wire the 4 tower speakers in parallel and run them off the other two channels at 2 ohms.
This is not ideal but I think it’s your best bet given the amps that you bought. Ideally, you should have bought a Kicker 700.5 instead of the second IX500.4 if you wanted to stick with two amps. Otherwise, you should buy a third amp, a mono amp for your sub and run your four tower speakers of your second IX500.4.
Al