Originally Posted by
philwsailz
This is tantamount to a thread hijack, but....
Cab-
You mention using the 4 full-range channels of the Kicker 700.5 in bridged mode to run the KMT6's. I think you might be unhappy with that setup. The KMT6 is nominally a 4-ohm speaker, but it has an impedance closer to 3-ohms. That is a little low to run on a bridged amp. If your 700.5 starts cutting out at high volume, this will be the reason why. It might work for you, and it might not.
If the KMT6's give the 700.5 fits, consider a different amp. An good example would be the ZX450.2 that delivers 150 watts into a 4-ohm load. That amp or another stereo amp like the 450.2 will run the KMT6's better than any bridged amp, due to the KMT6 impedance.
FYI-
Phil
Kicker