Adding 2nd set of JL 8.8’s to FX one tower.

Does anyone know where to source the FX one tower speaker brackets for JL 8.8’s?

Also, are the FX one towers pre wired for the second set of speakers?


Sent from my iPhone using Tapatalk

After doing some research, the brackets are not available and are Supra specific.

You also can’t but just the brackets from SC, you have to buy the whole JL 8.8 speaker with integrated FX one brackets.

So custom brackets it is or pipe mount as close to factory location.


Sent from my iPhone using Tapatalk

Or buy a new 2020 SA with 4 tower speakers and 2 12" subs :cool:

Quote:

---

Originally Posted by Prospersigman

Or buy a new 2020 SA with 4 tower speakers and 2 12" subs :cool:

---

That just might happen



Sent from my iPhone using Tapatalk

Quote:

---

Originally Posted by larry_arizona

That just might happen



Sent from my iPhone using Tapatalk

---

There will be deals to be had in 2020.

If anyone cares..... here are the factory brackets

https://uploads.tapatalk-cdn.com/202...ddd24a09e8.jpghttps://uploads.tapatalk-cdn.com/202...a26df3a2dc.jpg

FX one towers are pre wired for both sets of speakers.
https://uploads.tapatalk-cdn.com/202...c35d841a6d.jpg


Sent from my iPhone using Tapatalk

Also uses an amphenol 06-6s connector.
https://uploads.tapatalk-cdn.com/202...ddd7347e49.jpg


Sent from my iPhone using Tapatalk

I recall reading a few posts on social media about this. Someone was talking about a 17 and the wires zipped tied to the rest of the wires where they entered the boat from the tower. The person had to connect new wires to run them to where they wanted.

Sounds like you started taking things apart.

Quote:

---

Originally Posted by MJHSupra

Sounds like you started taking things apart.

---

Yep, it’s happening. Just need to find other end of speakers wires.....I am hoping they are behind the amp mounting board.


Sent from my iPhone using Tapatalk

I am completely audio install illiterate.

My current 2 tower JL8.8’s are run through a M400/4 like this.
https://uploads.tapatalk-cdn.com/202...9ef4fa41cf.jpg

I am swapping the M400/4 with a M800/8 like Supra does from the factory.

How should the M800/8 be wired with 4 JL8.8’s?


Sent from my iPhone using Tapatalk