Same here in DFW...here I go and buy a new boat with a heater planning on surfing well into November and it has been pouring down f'ing rain every weekend!! I dont mind cooler air and water temps but I want to have some sunshine!!
Printable View
Same here in DFW...here I go and buy a new boat with a heater planning on surfing well into November and it has been pouring down f'ing rain every weekend!! I dont mind cooler air and water temps but I want to have some sunshine!!
The GatorStep install came out awesome and feels phenomenal to walk on. [emoji41] https://uploads.tapatalk-cdn.com/201...5bfc428a5b.jpghttps://uploads.tapatalk-cdn.com/201...5aefb6c2a4.jpghttps://uploads.tapatalk-cdn.com/201...23f03c4eb1.jpghttps://uploads.tapatalk-cdn.com/201...849b82d09f.jpg
Sent from my SAMSUNG-SM-G935A using Tapatalk
That blue looks awesome against the black hull!
Damn that looks good I wanna steal that color since my interior is the same as yours but Mine won’t look that good against a white hull.
Sent from my iPhone using Tapatalk
Thank you sir!! It's always a gamble rolling the dice on something no one else has done yet.... but I like being a non-conformist :cool:
I still think it'd look good but truth be told, it just won't have that POP, like off the black deck.
That’ll be my winter project I’ll probably do the entire boat in a peanut butter I think that’ll look good. Problem is everything that came on my boat is black with a silver under tone I don’t think a black floor would look good in my boat.
Was it a pain to glue down?
Sent from my iPhone using Tapatalk
No, not at all. All the new pieces have 3M backing...I would cut the backing paper in the middle of a piece and fold like an inch back. Then I would position the piece and tape down one side, pull the backing and repeat for the other side.
The real pain is adhesive removal of the existing non-skid on the rear gunnels, swim platform, walk-through & V-drive hump. We're talking major sweat equity....it's nowhere near as simple as some youtube vids make it out to be. Even with the 3M adhesive remover wheel because that makes a huge mess and will overheat all but the most stout cordless drills.
Sweet thanks for the info
Sent from my iPhone using Tapatalk