Printable View
Anyone know how to, or If one can, engage or deploy the swell tabs when the boat is not moving, like on the trailer to test them? I'm trying to troubleshoot why my swell tabs don't work. I can do the center tab, but not sure about the swell tabs. 2015-17 Supra models
Sent from my SM-G965U using Tapatalk
You should be able to turn on the surf system to one side and it will instantly deploy the opposite tab.
I.e. if you select surf left, it should deploy the right tab immediately.
Sent from my iPhone using Tapatalk
Thanks, have you done this while the boat is not moving? The warning states that the cruise must be active between 9-12mph.
Sent from my SM-G965U using Tapatalk
I was looking for this info too, thought the plate only moved after reaching a certain speed.Quote:
Originally Posted by Boatlaunch
There's a dealer section in the settings, I've been trying to guess the code on/off hoping it would have a diagnostic screen.
On the Moombas it activates immediately and does not require a certain speed to deploy.
Sent from my iPhone using Tapatalk
I'd guess the Supras are same, not sure: On my Mojo the actuators go through a start-up sequence of movement when the key goes to the run position. You don't have to even crank it while its on the trailer. Just have someone move the key while you watch on the ground.
I believe there is a dealer code that can get you into this mode. I don’t know it, but someone probably does?
Sent from my iPhone using Tapatalk
I found the problem. This breaker was off, so no power to some of the toggles, the swell plates, and the steering column cruise adjust. The swell plates do adjust now from the screen, with the boat on the trailer. I can't believe I didn't check this earlier. https://uploads.tapatalk-cdn.com/201...ec1757da4e.jpg
Sent from my SM-G965U using Tapatalk
I recall during my dealer delivery, he showed me the breakers and said if anything stops working, check breakers first.
Glad it was simple.
Sent from my iPhone using Tapatalk