So here's how I mounted my zld in case anyone is doing this is the future. Just epoxied some erector set pieces on there. Used needle nose vise grips to hold while the epoxy was setting up.
Attachment 17191
Printable View
So here's how I mounted my zld in case anyone is doing this is the future. Just epoxied some erector set pieces on there. Used needle nose vise grips to hold while the epoxy was setting up.
Attachment 17191
I basically did the same, ran some short screws into the backside of the dash
That's how I did it on the LSV. Not sure where I want or how I'll mount the ZLD on my V.
http://img.tapatalk.com/d/13/04/21/umemyted.jpg