Printable View
take it apart and hook to a 12 v battery and see if it works. I use my jumper pack all the time to test things.
The Wal-Mart one had cut wires no harness, plus that harness does not match what SC uses, the deutch plugs
http://www.deutschconnector.com/prod...ay_connectors/
I went through this last year and replaced mine. I used to know where to order the triangle plug from but I cant remember at the moment. I redid mine and shrink wrapped all the new wiring with my heat gun. Note: Make sure when you install the new one to get it at the lowest point in the hull to help with the water.
Thanks, was going to shrink wrap it... since getting a new plug probably wont be possible in time.Quote:
Originally Posted by Jayrodau
the above link has the triangle plug as well. SC uses the square two pin.
btw, repair was quick and easy... remembered how bad I am at soldering. the heat shrink made it look good though..
note: know what took down the old bilge? it sucked up a piece of plastic of some sort... burned itself out auto bilging overnight.
Heat shrink makes us all look like pros! (Except for the guy who set the soldering iron down on the seat and burned a hole through it.)
i made sure to take everything i needed outside the boat on the picnic table.. and still did it on a chunk of extra woodQuote:
Originally Posted by kaneboats
I always brought a cardboard box in the boat with extra card board inside to make the soldering iron stays in the box or above the box, plus one on heat shrink.
Glad it was a fairly straight forward fix.
Well, I had a "matt" down and then bumped the cord, twisted the iron right off the matt and smelled the result.
:mad: ughhhhhhhQuote:
Originally Posted by kaneboats