I have an 18 MAX with the G6 ballast. The WakeMAKERS upgrade is 1K $$ is there a way to buy a smaller bag and plumb and stack it on top of the factory bag? Is it acceptable to do that?
Any suggestions?
Thanks in advance
Printable View
I have an 18 MAX with the G6 ballast. The WakeMAKERS upgrade is 1K $$ is there a way to buy a smaller bag and plumb and stack it on top of the factory bag? Is it acceptable to do that?
Any suggestions?
Thanks in advance
Save up and go the correct route.
If you put a ballast bag on top of another bag, it will push the water out of the bag underneath due to its weight, unless you use the overflow of the bottom bag to feed the upper bag.
But this solution is ghetto and could cause the upper bag to roll off and crash the engine diver panels and seriously fuck up your engine.
Do it right. You spent $80+k on a boat, don’t skimp out on $1k and cost yourself another $5k in repairing damage.
Buy once, cry once!
Sent from my iPhone using Tapatalk
anybody have pictures of the new wake makers bags installed...or just in general? Im curious to see what they did to get over the hump. Just presuming a couple of connections that go through the hump?
I can’t figure out why the 2018 exact fit bags are $999.99 and the 2019 exact fit bags are $1,499.99. Both show to be 1800 lbs...
Sent from my iPhone using Tapatalk