Makes sense, the extra I'm seeing is from the paint. Bummer.
Sent from my iPhone using Tapatalk
Printable View
Makes sense, the extra I'm seeing is from the paint. Bummer.
Sent from my iPhone using Tapatalk
The OZ is 1 7/8" and the OZ HD is ~ 2 3/8
Thanks for the info guys. I guess I don't have any complaints, no issues with my tower... Just thought I had the bigger one.
Sent from my iPhone using Tapatalk
On a '14 Mojo (OZ HD), adjusting the tension cable from the factory setting, the tower will hit the dash. (This is a tower without the HD lowering assist mechanism.)
If you have a spring axle trailer there is no option to lower the trailer without changing wheels, lower tires pressure, etc... If you have a torsion axle you have the option of moving the torsion arm, bringing the tire closer to the fender well. I have not personally done this but have read about others doing it on other forums.
Here is a shot of '14 Mojo and the tower (OZ HD) adjusted as low as possible without hitting the dash. The bimini sleeve in the tower tubing hits the outer edge of the dash.
A 7 foot door w Mojo, can if be done, might not be easy but is possible.
Attachment 19639
I think it's torsion....not sure since the boat is still a the dealer...he's supposed to adjust the cable so the tower is at the lowest position.... My Mondo will be on the water all summer long and will go to the garage only at the end of the season....so not that bad if I have to change the tire.....
She fits in the garage with 7' door. Had to adjust the height on the Fulton jack sand to allow the trailer to sit lower.
Where do you adjust the tower cable on a Mondo?
SurfSon
2014 Mondo