Would you mount this to the fiberglass base or cut a hole in it and mount it to the floor? I would love to put an adjustable one in. I sit on the cushion as well.
Printable View
Hey everyone ... I picked my new boat up in February and after the 4th trip out doing the engine break-in the wife was not happy with the seat height.
So to ensure my happiness and mainly to keep my wife happy I swapped it out with the following and cut 3" off of it with my power cutter:
Garelick 75530 12" Anodized Ribbed Seat Base
These guys have it for $59, I paid $80. http://www.boatersland.com/grl75530.html
Cutting and swapping out took about 30 minutes.
Works great and no more sitting on legs, pillows, towels, etc ... The nice thing is you can leave at 12" or cut down to your liking.
I tried the 12" height and it's wayyyy too high, so we found cutting it down to nine inches was good for both of us.
Just remember to measure, measure, measure, and cut once or make incremental cuts until you get the right height.
By the way, the adjustable one starts at 12" and goes to 17", so it would not be an option.
Our bolster smashes down and it looses its height somewhat from compression I also use the throwable but my wife needs a little more height she's short. lol
berg,
This mod has your name all over it! Get a few cases of beer & Newty and go for it!
http://www.alibaba.com/product-detai...979653324.html
It's the same exact base and tube as what came with the boat; just taller.
No mod required, just cut down the height and screwed it in.
Garelick is the brand that came with the boat.
It was real easy to cut and swap out.
I didn't take a before and after shot; but, going out tomorrow and I'll lift the seat off and take a pic; but, it looks like a factory pedestal.
Ok, then it is very different from my 07 LSV seat.
Currently away from boat. What is the height of the stock riser?