-
Ballast switch wiring
I'm installing a new ballast switch to control my IBS. I'm using a sprinkler valve so that I don't have to deal with vented loops and I'm not that concerned with fill time. Also using a dedicated pump. My question is: do I need to separately fuse-protect the sprinkler valve, or is the fused power wire coming into the switch enough? So the one fuse would be covering both the sprinkler valve and the fill pump?
-
So I got my IBS drain pumps wired and plumbed. I used a new switch from wakemakers and put it in the far right spot on the main switch panel, where the acc switch was. Like many have described here, the wiring diagram/instructions from wakemakers were backwards, meaning the drain pumps and fill pump spades are reversed. So I got that corrected. I have two T800's, on on each leg, for the drain pumps, each draining to new thru-hulls on each side of the boat. I have the fill pump hose and wiring run under the floor, so I just need to install the fill pump. I'm going to put a T on the stock intake, using the stock pump to fill the center sac, and a new T800 pump to fill the IBS. Then my goal is to drill a new intake on the port side of the bilge and have two T1200's, one for each of the rear sacs.