Printable View
For Sale. (4) Factory Kicker KM6130’s. $150.00 OBO. Purchased ’13 mojo Friday. Turned on factory speakers during dealer test drive. Replaced them Saturday with exile gear.
http://store.earmarkcaraudio.com/Xca...6&cat=0&page=1
Attachment 17377Attachment 17378Attachment 17379Attachment 17380
I tried to get a close up of the pig tail ends. The connect to the boat speaker wire then the plastic snaps around to protect the connections. Kind of neat.
Are these for the tower or in the boat seating area?
Those are the cabin speakers.
^^^what be said.
Would you split them up? Sell 2 at 75.00
Yes. Are you putting them in the bow of your mojo?Quote:
Originally Posted by smorris7
HAHA that's what i did in a way, i sold my 6 Kickers back to the Dealer so they could use them to upgrade 4 speaker systems in their current Mojo'sQuote:
Originally Posted by muehlcj
Yes i am. I'll take 2.
I sent you a PMQuote:
Originally Posted by smorris7
Money sent. Any feedback on instalation would be great. I can see and feel the cutouts behind the vinyl. What is the best way to cut the vinyl. Did they factory prewire the bow?
I think it might have been Ian but im not postive. Did an install on his friends LSV perhaps and did a front speaker addidition.Quote:
Originally Posted by smorris7
The hardest part is cutting the fabric so you can fold it back and make it look clean when you add the speakers. No i dont think the facotry adds the wires, but thats the easy part honestly.
The cut outs should be there, the factory isnt going to use two different panels such as that for speaker and no speaker options. They would only do the additional fabric cut out and mounting the speaker per the option.
Found the thread, post 35 I'd pm Ian Ashton see what his thoughts are.
https://forum.moomba.com/showthread....ghlight=stereo
Yes, bow is Pre-wired, but not connected to the headunit - unsure if factory amp is wired (both boats I've done didn't have factory amps).
Best way to cut the vinyl - feel for the center of the hole, then go to one edge and cross cut, then go 90 degrees in the other direction, basically making an X.
The hardest part is that the factory wires are really short, so you have to be careful to make sure they stay connected, or extend them.
Before;
http://img.tapatalk.com/d/13/06/02/7avuzy2a.jpg
After;
http://img.tapatalk.com/d/13/06/02/adere6yd.jpg
Hmm I could use the other two, I've got a couple that are busted in my boat. Shipping to 98272 (WA)?
I could take the other two. I have one blown one in the bow of my Mobius, but the tweeter still works. The shields over the speaker on these look beefier than mine too. My current ones are broken. Shipping to Utah (84094).
muehlcj, your inbox is full dude :)
Sorry. I cleaned it out.Quote:
Originally Posted by xBabyJesus