Ah perfectly understandable. Fried noggins must be properly cooled and cared for :-)
Printable View
Ah perfectly understandable. Fried noggins must be properly cooled and cared for :-)
Captn Kraig, you know the drill on mods.. pics or it never happened...LOL
Roger that. I'll snap a few of the devastation tonight. We are going to go out on the boat tonight, no boarding, just a ride and swimming, which is good as I have no ballast sysytem currently LOL. Oh, good reminder, I need to shut off the valves to my thru hulls for the ballast before launching! Bluub Bluub Bluub... boat's sitting awfully low in the water ain't it LOL
Still waiting on parts from WakeMakers, should be here Monday, until then no ballast.
Here is the port locker with divider wall and ballast pumps & mounting board removed and the port ballast fill/drain line run over to the starboard locker
Attachment 15023
This one is the Starboard locker with all of the lines pulled into it
Attachment 15024
This shows two water lines and the two power lines above the valve that I redirected to starboard rather than run them behind the muffler at the transom
Attachment 15025
This one shows how there isn't really any room between the muffler and transom
Attachment 15026
Making progess. Need to modify the pump & locker divider wall, basically reverse the panel & mounts but it doesn't quite fit the starboard locker so tear off existing carpet, trim to size, notch bottom for starboard side ballast fill/drain.
I also need to order some OEM carpet , about 2 by 6 feet is all to wrap divider wall once reveresed & trimmed and then to glue to the port side transom where I have a non OEM piece of carpet stuck back there for now.
Attachment 15126Attachment 15127