Printable View
My speedometer doesn't want to hold his speed. The arrow is always moving from 0 to the end of the cluster. Sometimes it stays on the speed for about 20-30 sec before going crazy again. Is there anything I can do about it before going to the dealer ($$) ?
I know I can take off the cluster under the steering wheel but just want to know before if this is a frequent problem.
Thank you
Boat is an moomba LSV 09
check the paddlewheel underneath first for any damage, then check wire connections on the inside at both the paddlewheel and all the way to the speedo. You can replace the paddlewheel assembly on your own for not too much $$ (if I remember correctly, Mike Mandley and/or Ian did this) before taking it to the dealer.
mine doesnt work haha..but on my outback its to easy to get to..i might replace the wheel assembly
Has anyone heard that excessive trailering can cause the paddle wheel to spin too fast thus messing up sensors. Mine was doing the same thing that you describe but no visible damage. Boat mechanic told me as much as I trailer I should put the blank in while trailering.
Bought a new paddle wheel on eBay 39.00 i think and fixed problem
Sent from my iPhone using Tapatalk
yes, I have heard that can happen but it might have been on here, so who knows if it's true, or not.
huh..never thought about that
Ok thank you i'll check on it
anyone have a link for a paddle wheel?
and let you know guys if not i'll look at the connections and the cluster
at least it's not the cluster
Paddle wheel is fine
Connector was ok
I'm trying this we everything if not it's the cluster
Sent from my SGH-I747M using Tapatalk 2
Update *****
Didnt found out the problem yet
Paddlewheel is ok and make move the speedometer
Connections are good on the cluster
???????
I dont know what to do (could it be the cluster or the speed calibration)
Sent from my SGH-I747M using Tapatalk 2