Long post, so bear with me.
I went round and round in my mind about whether to make a set of surf gates or tabs for my boat. Gates seemed easier, but when I made a ghetto gate to test the "proof of concept", the wave wasn't very good, and my boat didn't like it much. So tabs it is. https://uploads.tapatalk-cdn.com/201...9cdf8aa8ea.jpg
I looked at the tabs that come on basically all the manufacturers that used them, and ended up essentially copying what's on the MB boats.
I made about 100 drawings, and at least 3 cardboard mockups until I was happy with it, then gave those measurements to my buddy, who put them into CAD
https://uploads.tapatalk-cdn.com/201...c0eb42a9d1.jpghttps://uploads.tapatalk-cdn.com/201...20392a72d4.jpg