Printable View
I'm thinking about T-ing off one of my vent tubes and running it to the passenger side, so there is a pull-out tube under the passenger seat. Just curious if anyone has done this before, and if running a length that long will need an additional fan or anything - or if it will even work at that length.
My thought is that I'd have to run it up through the bow and back down.
There was talk of this but in the end if you just run them down the drivers side and exit at the floor, the tubs will extend to the passenger side and then no need to run them all the way around. Also with the these tubes unless you changed them to a hard tube anything that presses on them would flatten them cutting off air flow.
I was thinking something like PVC for the long runs, tucked up in the space between the outer hull and the top cap, so its out of the way. Its a pipe dream at the moment (pun intended!)
Ian,Quote:
Originally Posted by ian ashton
I think you'd almost need to run PVC because with the flex hose, I think that you would not have much air flow left but the time it went around the bow.
Al
why the need with the pull out tubes...?
Totally agreeQuote:
Originally Posted by jmvotto
Why not? Mostly because they don't reach to the back seat. I don't know, just thinking of another project. I'm also working on adding a pump to drain my cooler; why? 'cause.Quote:
Originally Posted by jmvotto
Ian, i put one behind the drivers seat.
Never mind, forgot you have a dd. Duh.
To start off, I don't have heat in my boat so I don't have any experience with it. But instead of running a heater tube up and all the way around the bow, why not just add a second heater to passenger side? I would think running water lines would be easier,more compact (than larger air hoses) and better heat output. Draw back is maybe cost, labor? and packaging the second heater core. How much will the air cool between the heater core and the outlet if the hose runs around the bow, kinda a long way for air. Just adding to your food for thought.
I put a 4 vent system in and I ran one around the open bow to under the passenger side. It works just fine with just the tubing they give you.
Ian, I am planning on putting in a vent right behind the drivers seat that will have enought hose to get too the back seats. I am planning on putting the hose above the main cabin speakers that are behind the drivers seat. It will be an easy run from the heater and will give enought hot air for the back people since the front heaters can reach the person sitting directly across from the driver. Hope this helps.