Al,
I got it figured out. I had forgotten to put the jumper from battery 1 to battery 2. Once I added that everything worked great. Thanks for checking back.
Printable View
Al,
I got it figured out. I had forgotten to put the jumper from battery 1 to battery 2. Once I added that everything worked great. Thanks for checking back.
Good to hear. I kinda felt responsible since you were following my diagram :)
The model # is 9100e? Ill have to take a picture tomorrow. No clue what am ACR is, and no there will not be an inboard charger at this time.
Thanks for replying to my pm Al.
I have to figure out a parts list other than the switch and some wire.
I may just end up paying to have this done when I get down to SC, too much going on with the move.
I have the 13 mojo2.5 and was wondering if I can run the SI wire to the starter or does it have to be wired to the key switch if anyone can help me out that would be great thanks!!
Riddle,
The SI terminal on the Blue Sea 7610 ACR needs to see battery voltage ONLY when the start is engaged. Exactly where you draw this from is not as important. But in all honestly, its a circuit thats rarely needed.