looking good.
Think I now know what what next winter season's project will be.
Printable View
looking good.
Think I now know what what next winter season's project will be.
Thanks Daze, everything got wired up yesterday to the amps. Right now it's all temporarily tied up, still gotta cover everything with split loom and secure permanantly. Going to run RCAs, remote wires and pull the sub today for a new bass knob to control sub volume. Whew! I want this one done!
Wiring is complete, added a volume control to the glove box for the cabin speakers. Thought up a cool method for powering the HU off the distribution block that looks like it will work well. Replaced the old Interstate lead acid battery with a Deka 31 AGM. Found a killer deal on a ProMariner ProSport 20 to keep the batts at peak performance, that goes in next week or so.
Covered all the wiring with black split loom ... and that's where I went from "I'm liking it" to "GEEZUS that looks like crap!". The split loom bulks up the wiring bundles twice over and they look huge! I was debating on whether to hide all the wiring before that, now I know i have to! I may have to re-route stuff to accomplish that, later though, it's boating time and i'm tired of doing this. That's a job for later
Gotta pull the sub & box out later today or tomorrow to prepare for adding an XRB1 sub control from Brian, might as well pull some new sub wire while in there.
Didn't get any pics the last few days, been going like a mad dog trying to wrap up and forget to take them. I'll get some tomorrow and post up. :D
Did you add cup holders net to the glove box, or did your boat come with them? That is something I've been wanting to do for a while, but I always forget to order 'em.
I have guys like to you to thank. Every time I think I'm getting closer I get to see how far I have to go. Looking good!
So I think I'm going to mimic your install on my boat, but in looking at the picture below I'm having trouble understanding how you have the ACR hood up;
https://forum.moomba.com/attachment....8&d=1304905238
To me it looks like you have both sides of the ACR wired to the same post on on the battery switch - or is that an optical illusion, with one of the wires passing through to the right side top post and one on the left side top post?
Its just the way has it wired threw the back of the switch. The posts are pretty close and to keep his wires looking clean he has them both entering the left side of the switch. I am quite positive its on the top left and right posts as this is how mine is done as well.
It looks great and is a good idea, much cleaner than running back to the batteries.
It's alive! :p
Finally got it done! Tested power just awhile ago and will tune tomorrow. Got a few minor things to do such as add wires to looms (below elec panel) but that's it!