Looking to add a bow bag to our LSV. Called wake makers and they said I would need to provide measurements of the bow bag I need? Can someone let me know what bow bag you use in your LSV?
Printable View
Looking to add a bow bag to our LSV. Called wake makers and they said I would need to provide measurements of the bow bag I need? Can someone let me know what bow bag you use in your LSV?
Got this one in my 2006 LSV, fits like a charm:http://windwardhosting.com/shuswap/p...Ballast-System
This should work just the same:https://www.wakemakers.com/fly-high-...d-bow-sac.html
I put this one (Straight Line Sumo Hidden Under Bow Bag (750 lbs) in my 2007 LSV and it fits really well. It's in the outlet section of Wakemakers - on sale for $246.49. You could also use a wake makers code and get it for 10% less.
https://www.wakemakers.com/straight-...-750-2016.html
Thanks guys, very helpful.
Best part of this the thread is the response time from people still rocking an LSV. Make no mistake, I've got MONDO CRAZy envy for all these new boats that's messin w/ my MOJO. Love this brand and the community that it's spawned/supports it.
Sumo 750 fits best, but the Fly High 650 is good too
^^^^^This. Absolutely love my LSV! Not to say I wouldn't mind a new boat but when I look at what I paid for mine when I bought it 4 yrs ago and what a new one would cost I love my boat even more.
Do you fill the bag with a portable pump? Looks like the opening to attach the pump to might be under the very front bow seat? Have you had an issue filling and draining with a portable pump?
I fill it with a portable pump - the new Sum Max Flow Ballast Pump. Eventually I would like to piggyback it off the center bag but currently this is what I use. Fills really fast too - like 5 minutes although I have not timed it. BTW, the link fill port on mine is on the port side not in the front like the picture shows. I bought it anticipating it being on the front of the bag but it is on the side.
Got it, thanks for the reply.
2008 LSV Integrated Bow Sac Install
Where did you guys run the intake hose to your bow sac? I’m adding a bow sac w/ dedicated reversible pump. Got the through hull and ball valve installed. I thought I could run it under the floor to the locker, install a “Y” and run hose to each leg of the sac by drilling a hole to the locker from each side of the bow storage compartment. However, there’s not enough room to pass it into the locker. I can run it under the port side seats to the bow, wanted to keep all the hose hidden.
Any suggestions or pictures that could help?
Thanks!!!!
Sent from my iPhone using Tapatalk Pro
Can't help you cuz mine is piggybacked off the center bag. Just a small hole in the floor under the port front seat.
I came off the vent port of my floor bag and into the starboard rear fill/drain port of my Sumo 750. It does not drain 100% all the time, but only leaves a gallon or two - really only a pain if you're wanting to remove the bag. That hole was extremely hard to drill... not so much for the physical drilling but the mental prep...
I leave a length of hose coiled (I call it a service loop) to allow the bag to stay flexible and not put a strain on the fittings.
Nice thing is you start filling the floor bag and stop when the cushions start to bulge. About the same amount of time it takes both of my 750 rears to fill. Draining works the same way.
https://i.imgur.com/UmAYJXh.jpg
https://i.imgur.com/cIQ1ld4.jpg
https://i.imgur.com/v381wJQ.jpg
I got a 650 up there from wakemakers. It was a combo with a pump/bag.
Welcome and Congrats! You will love this thread:
https://forum.moomba.com/showthread....highlight=love