also where did you find an extra Aware stereo control, I see you have one on the back of your boat.....
Printable View
also where did you find an extra Aware stereo control, I see you have one on the back of your boat.....
The OBV doesn't have much of a profile on the transom, so I don't really get any spray but your transom has quite a bit of contour. You could probably cut the edge of the gate closest to the stern to the transom profile and then just reattached it to the support arms a few inches from where it is right now. Basically cut the profile and "slide" the whole thing towards the stern.
^^^ what Joe said...
Just for the pic, it's small enough to fit in the rear storage no problem.
I find it steers ok while turning towards the side with the gate but like crap opposite side.
It does take some getting used to. I've adjusted our pickup to use the gate as advantage. I head at them then turn with the gate and swing the boat around in front of them, kinda like a dirt bike slide stop 180..
Thanks for the tip, I will give that a try.
Came with the boat, matching one next to the driver, love them both....
I am currently using a ratchet strap to secure it to the tie down on the opposite side. I have some ideas for version 2 and am hoping I can eliminate the strap. I do not put it on until we are ready to surf, either before or after the bags a re full. I have both regular and goofy riders, the ability to switch is nice, takes about 2 minutes to unhook, remove and replace on the opposite side.