2 Kicker 800.5s
lol I am going deaf
Sent from my iPhone using Tapatalk
Printable View
First thing done was to add short feet to the bottom of the floor to keep it level. The hump, which is getting cut off, supports the back of the floor. A level and sandpaper were used to make everything level front to back.
http://i1217.photobucket.com/albums/...218_193341.jpg
Next thing was to cut off the hump.
http://i1217.photobucket.com/albums/...225_190009.jpg
Designed and built the box using size suggested by Exile. Used 3/4 Birch plywood, glue, screws, and staples. Routered all the edges.
http://i1217.photobucket.com/albums/...9_204059_1.jpg
Used several coats of oil based paint inside and out and finished off with clear coat. Added carpet and electrical. Finished off with starboard feet to keep moisture from wicking up the carpet.
http://i1217.photobucket.com/albums/...206_194643.jpg
http://i1217.photobucket.com/albums/...206_195015.jpg
http://i1217.photobucket.com/albums/...206_194905.jpg
http://i1217.photobucket.com/albums/...206_195147.jpg
Finished box installed in the boat.
http://i1217.photobucket.com/albums/...2_153654_1.jpg
The box slid in and dropped in place behind the floor. Both sides were trimmed to match the contour of the hull and walkway wall.
Nice job .....
JL 12W7 in built to spec ported box, powered by Wetsounds SD2
http://uploads.tapatalk-cdn.com/2016...03653561ed.jpg
http://uploads.tapatalk-cdn.com/2016...34dc89bb05.jpg
http://uploads.tapatalk-cdn.com/2016...6d59c9f8ff.jpg
http://i.imgur.com/HTSQXbX.jpg
http://i.imgur.com/IKSQsrp.jpg
Sent from my SAMSUNG-SM-G930A using Tapatalk