Printable View
I used the 80 mil, and just kind of eyeballed how to arrange it to be most efficient.Quote:
Originally Posted by PJSurf
For tape I believe I used this, but any other similar brands should work fine:
Noico Tape Finishing Sealing Tape for car Sound deadening Installation https://www.amazon.com/dp/B071HX8JNK...ing=UTF8&psc=1
Based on this and others across the internet, I went with it. Hoping the pin doesn't cause us issue. I like the idea of not sitting on the bolster at all times.Quote:
Originally Posted by z28ke
I used 50mil just for ease of use and availability. It is nice that you can also double up during application at get 100mil. However, some spots the 50mil will bend easier so I left it single layer to save my fingers. I actually did both sides on the engine dividers completely. Trying to keep the plastic from vibrating in the tracks.Quote:
Originally Posted by z28ke
Not to hi-jack, but is it worth pulling the floor panel up? The v-drive cover, and dividers made sense, not sure about the floor.
To be honest it’s hard to say about the floor since I did it all at the same time. I’d try what you have and go from there before going through the trouble.
I ordered a batch, I'll try the dog house 1st then maybe under the center engine hatch storage tray.
I ordered some 3/8" thick adhesive backed sound insulation and did just the transmission cover on my Makai. It made a difference, but you can still hear the whine. I will do the floor panel next. https://uploads.tapatalk-cdn.com/202...33c25dc52a.jpghttps://uploads.tapatalk-cdn.com/202...1b46094988.jpghttps://uploads.tapatalk-cdn.com/202...c7c5a06df1.jpg
Sent from my moto z4 using Tapatalk
Kenny, I installed the seat riser on Moe Bubbles. Best mod I have done so far. Supper easy to install. 10 minutes maybe.
Followed this as I said before and did the dog house and the engine dividers. Was not that loud at all over the weekend. Installing my engine tray this weekend and I will cover the under side of it also.
Took advice and install the adjustable driver's seat mount. 12-18" - sitting on 15" increase now to see over the window tint. Wife loves it and she doesn't need the bolster now unless docking. Much more comfortable on the legs.
I'm thinking of getting one. Wife always has to stand when pulling me and I always have to sit on the bolster when it's rough and I need to see good. Is the pedestal secure and doesn't wobble? I want a taller base but also want it to feel tight and secure with no major wobble or movement when on the lake. Let me know y'alls thoughts who have upgraded the riser to the Garelick/EEz-In Blue Water Pedestal. Would love to hear a long term review now that the murder max has had it for a while.Quote:
Originally Posted by gphrph
I asked this same question a couple pages back. I know I bought 1 based on his answer.
We set ours at 15". My Mojo factory is 9", new unit all the way down is 12".
We love it. So much easier to see and the bolster now supports your legs and my wife does not have to stand. If you get the pin 100% engaged, then tighten the handle all the way, it does not move. We leave the swivel slightly loose so we can rotate, but no other movement.
Install is super easy, phillips screwdriver and about 10 minutes while the family was getting packed for the lake.