Printable View
I have two vents t’d from the top of the rear bags just like the mids in the pic, and you’ll want the check valve after the T that connects the rear and mid vents. See my lovely edit below; the green “squiggly” is where you put the check valves.
https://uploads.tapatalk-cdn.com/202...d29a6a9fc8.jpg
Thanks for the info! I’ll need to order some extra connectors to have two vents on the rear bags but no biggie. So the check valve basically will end up sort of next to the overflow thru hull fitting? Good to know!
Yep, the check valve is the last thing in the system before the thru hull fitting.
Got it and thanks for confirming. My boat is 1.5 hours away so I'm trying to do this upgrade in one trip with everything I need heh.Quote:
Originally Posted by z28ke
I should have realized I could have just stuck my finger in the check valve to see which way the flap went but yes blowing also works lol. The housing is also larger on the side the flapper has to fold into so that also should have been a clue for me lol. Regardless I went ahead and marked the flow direction so I don't forget when it comes time to install next week.
https://i.imgur.com/VmGecbd.jpg
https://i.imgur.com/JN6Qyjj.jpg
Based off your recommendation I realized I did not have enough bag and hose fittings to do two vents per each rear bag instead of one so I put in an order at WM this morning for them. I also ordered another pair of 1" Tee fittings so that I could make this plumbing network below. I think this is how I should do it similar to yours. I'm going to move my ballast sensor in between the check valve and the Tee fitting. Thoughts?
https://i.imgur.com/l5HXtBm.jpg
I’ve got Enzo’s in my mojo. They drain and fill well but after a bit of surfing it seems
I get a lot of air back in the bag. Does these check valves prevent that from happening? If so, I also plan to add a check valve to my
Front bow bag. Thanks for any info.
Please make a vid of your install. I have the WM upgrade kit as well and waiting to install once the boat is out of storage. BTW.. you are a diagram genius! So much easier to understand then trying to read the description of what is happening.
My new Makai gearbox has one heck of a high pitched scream when you put the rpm's to it. Did your Max do that, and did the sound dampening knock it down? We noticed it on the demo ride with the dealer too, and he said that's just a v drive for you. I was immediatly thinking about doing what you did.
Sent from my moto z4 using Tapatalk
Hah I like making the diagrams as it helps me understand what I need to do as well and what fittings I need to buy. Some of them are kind of pricey for what they are! Glad you enjoy them if it helps ya too!Quote:
Originally Posted by Ferns
I will for sure have a video of the install and how it does filling and draining. Hopefully no issues but if there are I’ll be sure to mention it and figure out what to do next. I’m glad this community likes to share tips and help everyone out. I’ve learned a lot from the community here and very thankful of it!
“They” say not to do that on the front bow bag because it is piggybacked off the hard center tank, which you could supposedly tin can when pulling vacuum. I have doubts since even with the check valves on my rears the bags almost never get all the water out and suck flat.Quote:
Originally Posted by jnr4817
Yes the raptors are pretty loud IMO, the sound dampening was certainly worth the time and money.Quote:
Originally Posted by HFarr