That means the surf tabs are deployed at 70% starboard side, for port side surfing.Quote:
Originally Posted by snyderaaron
check your switch for surfing to make sure it is centered.
I think that is a common fault code and you can ignore it.
Printable View
That means the surf tabs are deployed at 70% starboard side, for port side surfing.Quote:
Originally Posted by snyderaaron
check your switch for surfing to make sure it is centered.
I think that is a common fault code and you can ignore it.
From Engine Nut in March
SPN 707 FMI 3
The trouble code SPN 707 FMI 3 is a low oil level code. Check your oil level. If it is OK, check to make sure the oil level switch on the side of the oil pan is plugged in. The ECM sets the code if it detects an open circuit at the level switch about 20 seconds after the engine is turned off.
So your telling me this who time when I set the tabs for say like 50-port and 60-starboard it's not deploying to that because I flipped the switch to surf port?Quote:
Originally Posted by lsupcar
I assumed I had to in order to deploy the tabs.
Sent from my iPhone using Tapatalk
I am not following your grammar.Quote:
Originally Posted by snyderaaron
Push the surf switch toward the direction you want to surf. On the vessel settings scroll down to the side you are surfing on, port or starboard, depending on which way you moved the switch, then use the return button to scroll up the percent tab deployment. 70% on each side is not a bad choice.
You have to choose one side or the other.
This is probably mentioned in the owners manual.
I was assuming that both tabs were deployed when you surfed one side.
Sent from my iPhone using Tapatalk
ok
No, if you surf to port, only the starboard tab will deploy to the percent you set on the gauge. Vice versa for the other side.