Printable View
I know some of you have had to add additional reinforcement to the removable engine sidewall panels. Do any of you have pictures of what you have done? I am not talking about the aluminum track at the bottom, I already have that. I am still experiencing some bowing of the panel itself and was going to add a stiffener or two. Just curious what others are doing.
Sent from my iPhone using Tapatalk
This is the panel that I have. As you can see it already had some built in channels for reinforcement, but they are not enough.
https://uploads.tapatalk-cdn.com/202...1aa72aa70e.jpg
Sent from my iPhone using Tapatalk
So my 2017 had the metal reinforcement channels on the panels themselves just like yours, I went ahead and added the Wakemakers panel saver kit to them as well.
On the engine side of the panels I also added Aluminum 'L' stock taller than the panel channel to keep panel from jumping track.
These mods keep my Enzos in check [emoji57]https://uploads.tapatalk-cdn.com/202...661640374f.jpghttps://uploads.tapatalk-cdn.com/202...9e58880fa9.jpg
Sent from my Note9 using Tapatalk
Nice! Thanks. I will check out the panel saver kit.
Sent from my iPhone using Tapatalk