Printable View
After getting my amp rack back in for the reinstall, I have one wire coming over with the others from the head unit that I can't figure out or remember what it is. It's yellow and black striped. It had to be hooked with the old amp somehow because it didn't have a ring terminal for the distro block.
Is this a ground that needs hooked up?
I should mention that this is from 2016 Mojo, Fusion Head Unit that had the factory Kicker 200.2 amp running the towers.
Bump......Dusty, MLA, TruKaotik, BrettLee, any of you all have some insight. Just want to be sure before powering up and harming something. I should note that its black with yellow stripe, not the other way around. Some poking around on the net lends to a kill switch wire, but again, I'm not sure why that wouldn't have been grounded elsewhere? Is that something that Moomba would have done is just jam that in at the amp ground location for convenience?
Is it the remote turn on wire for the amp?
Sent from my iPhone using Tapatalk
No, at least I assume. I have the blue and white stripe coming there in the same location that is the standard convention for the amp remote turn-on.
Not sure what else it could be. 12 volt power, Ground and remote are all the connect to the amp on the power side.Quote:
Originally Posted by BigOrange
Sent from my iPhone using Tapatalk
Yes, it's the ground for your head unit. I just went through this the other day. My head unit wouldn't turn on because I didn't reconnect that ground. I traces the wire back to the HU, where it was labeled "ground"
Great, thanks!Quote:
Originally Posted by mattsask
Sorry... I havnt ran into a yellow/black but they do run a ground over since late 15' for noise.. mine have all been black, if it was a dealer fix, they used what they had..